8. Select cycle |
|
| 10. Select cycle options | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Turn cycle knob to choose your wash cycle. For more information, see “Control Panel.”
9. Select cycle settings
Once you select a cycle, the default settings for that cycle will be lit. Press the cycle settings buttons to change the Temperature, Soil Level, and Spin Speed, if desired.
NOTE: Always read and follow fabric care label instructions to avoid damage to your garments.
Wash Temp | Suggested Fabrics | |
|
| |
Hot | Whites and pastels | |
Some cold water is added to save | ||
energy. This will be cooler than | Durable garments | |
your hot water heater setting. | ||
Heavy soils | ||
| ||
|
| |
Warm | Bright colors | |
Some cold water will be added, | ||
so this will be cooler than what | Moderate to light soils | |
your previous washer provided. |
| |
|
| |
Cool - brights/darks |
| |
Warm water is added to assist | Colors that | |
in soil removal and to help | bleed or fade | |
dissolve detergents. | Light soils | |
|
| |
Cold | Dark colors that | |
Warm water may be added to | ||
assist in soil removal and to help | bleed or fade | |
dissolve detergents. | Light soils | |
| ||
|
|
Select any other cycle options you may wish to add, if not previously set. Some cycles will automatically add certain options such as Extra Rinse. These can be turned off, if desired.
NOTE: Not all options are available with all cycles.
11. Press START/Pause/Unlock to begin wash cycle
Press the START/Pause/Unlock button to start the wash cycle. Filling is delayed for several minutes while load balance is sensed.When the cycle has finished, the DONE indicator will light. Promptly remove garments after cycle has completed to avoid odor, reduce wrinkling, and rusting of metal hooks, zippers, and snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/Pause/Unlock; the lid will unlock once
the washer movement has stopped. This may take several minutes if the load was spinning at high speed. Then close the lid and press START/Pause/Unlock again to restart the cycle.
If lid is left open for more than 10 minutes, water will pump out.
Delay in water fill
Filling is delayed for 2 to 3 minutes to check for load unbalance. You will hear the hum of the spin prior to filling. This is normal operation.
8