Samsung BFW36W Temperature control feature as your Washer determines, Temperature of the water

fills with the wrong

•

Turn both faucets on fully.

temperature water.

• Make sure the temperature selection is correct.

• Make sure the hoses are connected to the correct faucets.

Flush water lines.

• Check the water heater. It should be set to deliver a minimum 120°

F (49° C) hot water at the tap. Also check the water heater capacity

and recovery rate.

• Disconnect the hoses and clean the screens. The hose filter screens

may be plugged.

• As your Washer is filling, the water temperature may change as

the automatic temperature control feature checks incoming water

temperature. This is normal.

• While your Washer is filling, you may notice just hot and/or just

cold water going through the dispenser when cold or warm wash

temperatures are selected. This is a normal function of the automatic

temperature control feature as your Washer determines the

temperature of the water.

door locked or will not

•

Press the Start/Pause Button to stop your Washer.

open.

• Your Washer door will remain locked during the heating portion of the

Sanitize Cycle

• It may take a few moments for the door lock mechanism to

disengage.

does not drain and/or spin.

•

Check the fuse or reset the circuit breaker.

• Straighten the drain hoses. Eliminate kinked hoses. If there is a drain

restriction, call for service.

• Close the door and press the Start/Pause Button. For your safety,

your Washer will not tumble or spin unless the door is closed.

load is too wet at the end of

•

Use the High spin speed.

the cycle.

• Use high efficiency detergent to reduce over–sudsing.

• Load is too small. Very small loads (one or two items) may become

unbalanced and not spin out completely.

leaks water.

•

Make sure the door is firmly closed.

• Make sure all hose connections are tight.

• Make sure the end of the drain hose is correctly inserted and secured

to the drainage system.

•

Avoid overloading.

• Use high efficiency detergent to prevent over–sudsing.

has excessive suds.

•

Use high efficiency detergent to prevent over-sudsing.

• Reduce the detergent amount for soft water, small or lightly soiled

loads.

• Non-HE detergent is NOT recommended.