Kenmore 240-Volt Compact Electric Dryer, 110.84182 Wire connection Power supply cord, Cde Deg

Electrical Connection		Options
If your home has:		And you will be			Go to Section
		connecting		to:
4-wire	receptacle	A UL listed,			4-wire	connection:
(NEMA Type 14-30R)		120/240	volt		Power	supply cord
		30 amp,	dryer
		power supply
		minimum,
		cord*
4-wire	direct	A fused			4-wire	connection:
		disconnect		or	Direct Wire
		circuit breaker
		box*
3-wire	receptacle	A UL listed,			3-wire	connection:
(NEMA type 10-30R)		120/240	volt		Power	supply cord
		30 amp,	dryer
		power supply
		minimum,
		cord*
3-wire	direct	A fused			3-wire	connection:
		disconnect		or	Direct	Wire

circuit breaker box*

*If local codes do not permit the connection of a frame-grounding conductor to the neutral wire, go to "Optional 3-wire connection" section.

4-wire connection: Power supply cord

IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit the use of 3-wire connections.

BF

1= Remove center terminal block screw.

2.Remove neutral grounding wire (green with yellow stripes) from external ground conductor screw. Fasten it under center, silver-colored terminal block screw.

A B

0

C

A. External ground conductor screw - Dotted line shows

position of NEUTRAL grounding wire before being moved to center terminal block screw

B. Center silver-colored terminal block screw

C. Green/yellow wire of harness

3.Connect ground wire (green or bare) of power supply cord to external ground conductor screw. Tighten screw.

4.Connect neutral wire (white or center wire) of power supply cord under center screw of the terminal block.

CDE

1...... I°

A

F

C DEG

A. 4-wire receptacle (NEMA type 14-30R) B. 4-prong plug

C. Ground prong D. Neutral prong

E, Spade terminals with upturned ends F. _" (1.9 cm) UL listed strain relief

G. Ring terminals

A. _" (1.9 cm) UL Iisted strain relief

B. Ground wire (green or bare) of power supply cord

C. External ground conductor screw

D. Center silver-colored terminal block screw

E. Neutral wire (white or center wire)

E Neutral grounding wire (green with yellow stripes)

5.Connect the other wires to outer terminal block screws. Tighten screws.

6.Tighten strain relief screws.

7.Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw.