Unpacking/Setting Up | American Dryer Corp MLG-130DR (HSI) manual

B. UNPACKING/SETTING UP

Remove protective shipping material (i.e., plastic wrap and/or optional shipping box) from dryer.

IMPORTANT: Dryer must be transported and handled in an upright position at ALL times.

The dryer can be moved to its final location while still attached to the skid or with the skid removed. To un-skid the dryer, locate and remove the four (4) lag bolts securing the base of the dryer to the wooden skid. Two (2) are at the rear base, and two (2) are located in the bottom of the lint chamber. To remove the two (2) lag bolts located in the lint chamber area, remove the lint drawer and the three (3) Phillips head screws securing the lint door in place.

1.Leveling Dryer

a.To level the dryer, place 4-inch (10.16 cm) metal shims (refer to the illustration) or other suitable material under the base pads. It is suggested that the dryer be tilted slightly to the rear.

2. If more headroom is needed when moving the dryer into position, the top console (module) may be removed. To remove the Top Console (module);

a. Rear of Dryer (refer to the illustration on page

12)...

1) Disconnect the four (4) pin “EMERGENCY STOP” (E-Stop) Connector B .

2) Remove the Drive Motor “blue” wires C marked 1, 2, 3 from the Drive Motor Reversing Contactor T1, T2, T3.

3)Remove the Blower Motor “red” wires D marked 1, 2, 3 from the Blower Motor Overload T1, T2, T3.

4)Disconnect the two (2) pin Rotational Sensor Connector E . b. Front of Dryer...

1)Open the Control Door

a)Remove the Phillips head screw from the bottom right of the Phase 6 Microprocessor Controller (computer) Keyboard (touchpad) Panel Assembly.

b)Open the keyboard (touchpad) door.

2)Disconnect the four (4) pin connector.

3)Disconnect the two (2) pin connector.