American Dryer Corp MLG-130DR (HSI) installation manual Operating Instructions, Basket Coating

Page 33

2)Spin and stop times are adjustable in the Manual (timed) Mode. b. Dual Timer Dryer Models

1)Both spin time and stop (dwell) time are adjustable (refer to page 36).

BASKET COATING

The tumbler (basket) is treated with a protective coating. We suggest dampening old garments or cloth material with a solution of water and non-flammable mild detergent and tumbling them in the tumbler (basket) to remove this coating.

8.Each dryer should be operated through one (1) complete cycle to assure that no further adjustments are necessary and that ALL components are functioning properly.

9.Make a complete operational check of ALL operating controls.

a.Microprocessor controller (computer) programs/selections...

1)Each microprocessor controller (computer) has been preprogrammed by the factory with the most commonly used parameter (program) selections. If computer changes are required, refer to the computer programming manual which was shipped with the dryer.

b.Dual Timer check...

1)Heating Timer

2)Cool Down Timer

3)Temperature Selection Switch

J.OPERATING INSTRUCTIONS

NOTE: Before attempting to start the dryer be sure that the main door is closed and the lint drawer is securely in place.

1.To start the dryer:

a. Microprocessor (computer) dryers...

1)L.E.D. (light emitting diode) display will read “REAdY” (meaning no cycle in progress).

2)Press the letter on the keyboard (touchpad) corresponding to the cycle desired (i.e., Key “E”)...

a)The dryer will then start (rotate).

3)L.E.D. display will now show “Cycle In Progress” and “Cycle Status” meaning that the dryer is in the drying cycle (dry mode for 30 minutes) and count downwards in minutes.

29

Image 33
Contents MLG-130DR HSI Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Section Procedure for Functional Check of Replacement Important Information SectionWhat to do if YOU Smell GAS Safety PrecautionsPage Specifications SPECIFICATIONS/COMPONENT IdentificationSpecifications Dryer Front View Illus. No Component IdentificationDryer Rear View Illus. No Location Requirements Installation ProceduresRear of Dryer refer to the illustration on UNPACKING/SETTING UPPage Dryer Enclosure Requirements Fresh AIR Supply Requirements Exhaust Requirements Be Reduced Anywhere Down Stream of the Dryer Page Multiple Dryer Common Venting Page Electrical Requirements Electrical InformationMLG-130DR Gas Electrical Service SpecificationsElectrical Connections GAS Information Gas Connections Inlet connection ---------- 1-inch N.P.T Technical Data Gas SpecificationsLiquid Propane L.P. Gas Type of GasPage Preoperational Tests Preparation for OPERATION/START-UPGas Basket Coating Operating InstructionsShut Down Instructions SERVICE/PARTS Information ServiceParts Warranty Information Returning Warranty CardsReturning Warranty Parts Page Cleaning Routine MaintenanceLubrication AdjustmentsTiming Legend Reversing Timer SPIN/DWELLADJUSTMENTSProcedure for Functional Check Replacement Components Page Start the drying cycle For Phase 6 Models Manual Reset HI-LIMIT InstructionsADC113130 1- 03/28/00-25