4)Disconnect the two (2) pin connector from the Phase 6 Microprocessor Controller (computer). Refer to the wiring diagram on the Control Door.
5)Disconnect the ground (GND) wire from the Phase 6 Microprocessor Controller (computer).
NOTE: b 2 and b 3 apply only to models manufactured after August 1997. Models manufactured prior to August 1997 require a Pin Extraction Tool (ADC Part No. 122800) to remove the pins from their connectors.
c.Top of Dryer (refer to the illustration below)...
1)Remove the eight (8) sets of nuts and washers F holding the console (module) to the base.
IMPORTANT: The dryer must be transported and handled in an upright position at ALL times.
12