American Dryer Corp MLG-130DR (HSI) installation manual Table of Contents

Page 5

	Table of Contents
SECTION I
IMPORTANT INFORMATION		3
A. Receiving and Handling		3
B.	Safety Precautions	4
SECTION II
SPECIFICATIONS/COMPONENT IDENTIFICATION		6
A. Specifications		6
B.	Component Identification	8
SECTION III
INSTALLATION PROCEDURES		10
A. Location Requirements		10
B. Unpacking/Setting Up		11
C. Dryer Enclosure Requirements		13
D. FreshAir Supply Requirements		14
E.	Exhaust Requirements	15
F.	Electrical Information	20
G.	Gas Information	23
H. Preparation For Operation/Start-Up		27
I.	Preoperational Tests	27
J.	Operating Instructions	29
K. Shut Down Instructions		30
SECTION IV
SERVICE/PARTS INFORMATION		31
A. Service		31
B. Parts		31
SECTION V
WARRANTY INFORMATION

A.	Returning Warranty Card(s)	32
B.	Parts	32
C.	Returning Warranty Part(s)	32

Image 5

Contents MLG-130DR HSI Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Section Procedure for Functional Check of Replacement Important Information SectionWhat to do if YOU Smell GAS Safety PrecautionsPage Specifications SPECIFICATIONS/COMPONENT IdentificationSpecifications Dryer Front View Illus. No Component IdentificationDryer Rear View Illus. No Location Requirements Installation ProceduresRear of Dryer refer to the illustration on UNPACKING/SETTING UPPage Dryer Enclosure Requirements Fresh AIR Supply Requirements Exhaust Requirements Be Reduced Anywhere Down Stream of the Dryer Page Multiple Dryer Common Venting Page Electrical Requirements Electrical InformationMLG-130DR Gas Electrical Service SpecificationsElectrical Connections GAS Information Gas Connections Inlet connection ---------- 1-inch N.P.T Technical Data Gas SpecificationsLiquid Propane L.P. Gas Type of GasPage Preoperational Tests Preparation for OPERATION/START-UPGas Basket Coating Operating InstructionsShut Down Instructions Parts SERVICE/PARTS InformationService Returning Warranty Parts Warranty InformationReturning Warranty Cards Page Cleaning Routine MaintenanceLubrication AdjustmentsTiming Legend Reversing Timer SPIN/DWELLADJUSTMENTSProcedure for Functional Check Replacement Components Page Start the drying cycle For Phase 6 Models Manual Reset HI-LIMIT InstructionsADC113130 1- 03/28/00-25