Maytag W10150661A, W10150660A Installation Instructions, Tools and Parts, Location Requirements

Page 5

INSTALLATION INSTRUCTIONS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Location Requirements

WARNING

8" or 10" pipe wrench

8" or 10" adjustable wrench (for gas connections)

Flat-blade screwdriver

Adjustable wrench that opens to 1" (2.5 cm) or hex-head socket wrench (for adjusting dryer feet)

Level

¼" nut driver or socket wrench

Knife

Vent clamps

Pipe-joint compound resistant to LP gas

Caulking gun and compound (for installing new exhaust vent)

Pliers

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor for a garage installation.

Parts supplied:

Remove parts package from dryer drum. Check that all parts were included.

4 leveling legs

Parts needed:

Check local codes and consult gas supplier. Check existing gas supply, electrical supply and venting, and read “Electrical Requirements,” “Gas Supply Requirements” and “Venting Requirements” before purchasing parts.

Mobile home installations require special parts (listed following) that may be ordered by calling the dealer from whom you purchased your dryer. For information on ordering, please refer to the “Assistance or Service” section. You may also contact the dealer from whom you purchased your dryer.

Mobile home installation kit. Ask for Part Number 346764.

Metal exhaust system hardware.

Failure to do so can result in death, explosion, or fire.

You will need

A location that allows for proper exhaust installation. See “Venting Requirements.”

A separate 30-amp circuit.

A grounded electrical outlet located within 2 ft (61 cm) of either side of the dryer. See “Electrical Requirements.”

A sturdy floor to support the total weight (dryer and load) of 200 lbs (90.7 kg). The combined weight of a companion appliance should also be considered.

A level floor with a maximum slope of 1" (2.5 cm) under entire dryer.

Do not operate your dryer at temperatures below 45ºF (7ºC). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended.

The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes or sleeping quarters. Contact your local building inspector.

NOTE: No other fuel-burning appliance can be installed in the same closet as a dryer.

5

Image 5
Contents W10150660A Sécheuse À GAZ Bravostm Avec Système DE Soin DES TissusTable DES Matières Table of ContentsYour safety and the safety of others are very important Dryer SafetyImportant Safety Instructions Location Requirements Installation InstructionsTools and Parts Mobile home Additional installation requirements Installation ClearancesMobile home installations require Dryer DimensionsGas Supply Requirements Electrical RequirementsGas Type Gas Supply LineGas supply connection requirements Venting RequirementsBurner Input Requirements Dryer Gas PipeIf this is a new vent system Vent material If using an existing vent systemPlan Vent System Special provisions for mobile home installationsInstall Leveling Legs Install Vent SystemVent system chart Determine vent pathLevel Dryer Make Gas ConnectionConnect Vent Reinstall the door Remove the door assemblyReverse Door Swing Reverse the strikeInstall these screws first If the dryer will not start, check the following Complete InstallationStarting Your Dryer Dryer USEDrying and Cycle Tips Stopping, Pausing or RestartingTo stop or pause your dryer at any time To restart the dryerCycles Status LightsModifiers Changing Cycles, Modifiers and Options End of Cycle SignalOptions Drying Rack Option Rack Dry Setting Temp Time Wool SweatersTo use the drying rack Stuffed toys or pillowsCleaning the Lint Screen Cleaning the Dryer LocationCleaning the Dryer Interior Dryer CareChanging the Drum Light Removing Accumulated LintVacation and Moving Care Dryer Results TroubleshootingDryer Operation Lint on load Cycle time too shortStains on load or drum Loads are wrinkledAccessories Assistance or ServiceU.S.A CanadaONE Year Limited Warranty Maytag Corporation Major Appliance WarrantyPage Votre sécurité et celle des autres est très importante Sécurité DE LA SécheuseImportantes Instructions DE Sécurité Outillage et pièces Instructions D’INSTALLATIONExigences d’emplacement Dégagements de séparation à respecter Dimensions de la sécheuseLinstallation dans une maison mobile exige Alimentation en gaz Spécifications électriquesType de gaz Gaz naturelExigences concernant le raccordement au gaz Canalisation d’arrivée de gazCaractéristiques d’alimentation du brûleur Canalisation d’arrivée de gaz de la sécheuseEn cas dutilisation du système dévacuation existant Exigences concernant lévacuationÉvacuation Planification du système d’évacuationTableau des systèmes dévacuation Autres installations où le dégagement est réduitDéterminer litinéraire dacheminement du conduit Installation des pieds de nivellement Installation du système d’évacuationRaccordement au gaz Pour utilisation dans une maison mobileRéglage de laplomb de la sécheuse Raccordement du conduit d’évacuationInversion de la gâche Inversion du sens douverture de la porteDépose de la porte Réinstallation de la porte Si la sécheuse ne démarre pas, vérifier ce qui suit Achever l’installationMise en marche de la sécheuse Utilisation DE LA SécheusePour remettre la sécheuse en marche Arrêt, pause ou remise en marchePour mettre la sécheuse en pause ou larrêter à tout moment Témoins lumineux Conseils pour le séchage et les programmesProgrammes Modificateurs Signal de fin de programme Utilisation de la grille de séchage Option de grille de séchageModification des préréglages de niveau de séchage Nettoyage du filtre à charpie Nettoyage de lemplacement de la sécheuseEntretien DE LA Sécheuse Retrait de la charpie accumulée Nettoyage de l’intérieur de la sécheuseDéménagement Changement de l’ampoule d’éclairage du tambourRésultats de la sécheuse DépannageFonctionnement de la sécheuse Charpie sur la charge Temps de programme trop courtTaches sur la charge ou sur le tambour Charges avec faux plisAccessoires Assistance OU ServiceAu Canada Si vous avez besoin de pièces de rechangeGarantie DES Gros Appareils Ménagers Maytag Corporation W10150660A SP PN W10150661A

W10150661A, W10150660A specifications

The Maytag W10150660A and W10150661A are two exceptional models designed to enhance the user experience in home laundry. They showcase advanced features and sophisticated technologies that cater to the evolving needs of modern households.

One of the standout characteristics of both models is their robust build quality, reflecting Maytag's commitment to durability and reliability. Made from high-grade materials, these units offer a long lifespan, ensuring they can handle even the toughest laundry loads. This is especially important for larger families or those who regularly do extensive laundry.

The W10150660A and W10150661A feature innovative washing options that allow users to customize their laundry experience. With multiple wash cycles, including options for heavy-duty, delicate, and quick washes, the models can adeptly manage any type of fabric, providing the right care for every garment. This versatility makes them ideal for households with diverse laundry needs.

Energy efficiency is another hallmark of these Maytag models. They come equipped with advanced technologies designed to minimize water and energy consumption without compromising cleaning performance. This not only helps in reducing utility bills but also aligns with environmentally friendly practices, making them a responsible choice for eco-conscious consumers.

Both the W10150660A and W10150661A utilize a powerful agitator system that ensures thorough cleaning by effectively removing dirt and stains from fabrics. The robust motor delivers optimal torque, allowing the units to tackle even the most stubborn grime with ease.

Additionally, these models are designed with user convenience in mind. The intuitive control panels are straightforward and easy to navigate, enabling users to select their desired settings with minimal effort. Features such as time delay options and automatic dispensers further streamline the laundry process, offering additional flexibility to accommodate busy lifestyles.

The spacious drum capacity provided in both models allows for handling larger loads, reducing the number of cycles needed for laundry. This not only saves time but also makes laundry days more efficient.

In summary, the Maytag W10150660A and W10150661A combine durability, versatility, energy efficiency, and user-friendly features. These models stand out as reliable allies in tackling laundry challenges, making them an excellent addition to any modern home.