![](/images/new-backgrounds/1328752/32875221x1.webp)
C ii:ii,iii!!ii¸¸iJil!iiiii¸:ii,i!!i!illi:I'e_;i¢,i_ii:o::
IMPORTANT." Your dryness [eve[ settings can be adjusted to adapt
to different installations, environmental conditions, or persona[ preference. This change is retained and will affect all of your Auto Cycles, not just the current cycle/load.
If all your loads on all Auto Cycles are consistently not as dry as you would like, you may change the default settings to increase the default dryness [eve[. This change will affect all of your Auto Cycles.
There are 3 drying settings, which are displayed using the WET, DAMP, and COOl. DOWN indicators:
time more (_
less
time
[]
wrinkle
prevent
options and modifiers | p,o,,_,o_dtO_ockiooto,, |
| controls |
1.(factory preset dryness level) - WET indicator lit.
2.(slightly drier clothes, 15% more drying time) - WET and DAMP indicators lit.
3, (much drier clothes, 30% more drying time) - WET, DAMP, and COOl. DOWN indicators [it.
To change the Dryness Level settings:
NOTE: The Dryness I.eve[ settings cannot be changed while the dryer is running.
1.Press and hold the TEMPERATURES button for at least
6 seconds. The dryer will beep, and the current drying mode will be displayed.
2.To select a new drying setting, press the TEMPERATURES button again until the desired drying setting is shown.
NOTE: While cycling through the settings, the current setting will be [it solid, but the other settings will flash.
3, Press the START/PAUSE button to save the drying setting and exit to standby mode.
NOTE: To exit without saving, press the POWER/CANCE[ ....
button.
4, The drying setting you selected will become your new preset drying setting for all Auto Cycles.
11