Radio Shack HTX-10 owner manual

Page 15

Follow these steps to install the transceiver as a base station.

1.Mount the base station antenna as described in its owner's manual.

Warning: Use extreme caution when you install or remove a base station antenna. If the antenna starts to fall, let it go! It could contact overheard power lines. If the antenna touches a power line, contact with the antenna, mast, cable, or guy wires can cause electrocution and death. Call the power company to remove the antenna. DO NOT attempt to do so yourself.

2.Connect the antenna to the ANT jack on the back of the transceiver.

3.Connect the transceiver's black power wire to the negative

(–) terminal on the DC power supply.

4.Connect the transceiver's red wire (with in-line fuse holders) to the positive (+) terminal on the DC power supply.

5.Connect the single–connector end of the power cord to the connector on the back of the transceiver.

6.Connect the DC power supply to a standard AC outlet.

15

Image 15
Contents HTX-10 Features Page FCC Information Manual ConventionsContents Introduction to Amateur Radio Page Preparation Attaching the Microphone HolderMounting the Transceiver Page Connecting AN Antenna Page Connecting AN Optional External Speaker Connecting the MicrophoneFrame chassis ground Using Vehicle Battery PowerUsing the Transceiver AS a Base Station Page Quick Look AT the Controls Operation Setting Squelch and ReceivingTransmitting Page Using the Special Features Special FeaturesUsing Step Using Scan Using CallUsing LCR Last Channel Recall Using M-LOADUsing NB Noise Blanker Using T-LOW Tone-Low Using ShiftUsing Fine Clarifier Using M-SAVE Memory SaveUsing RF-G RF Gain Using MIC-G Microphone GainTurning the KEY Tone on and OFF Care and Maintenance Problem Possible Causes Remedies TroubleshootingNoise Reduction Replacing the Fuse Page General SpecificationsTransmitter Page Page RadioShack Division of Tandy Corporation Fort Worth, Texas