Radio Shack HTX-10 owner manual Using Shift, Using T-LOW Tone-Low

Page 24

Using SHIFT

The transceiver’s shift function lets you set the transmit frequency shift from the receive frequency in either direction within the range of 0.0 Hz to 990 kHz.

Follow these steps to set the frequency shift direction and offset frequency.

1.To set the frequency shift direction to +, press PUSH FUNC then press SHIFT while FUNC appears. +SHIFT appears. Press PUSH FUNC and SHIFT again while FUNC appears to set the frequency shift direction to -. -SHIFTappears.

2.Press PUSH FUNC then SHIFT for about 3 seconds. 000 appears.

3.Rotate TUNE to set the offset frequency to any frequency from 0 to 990 kHz.

4.To exit, hold down PUSH FUNC and SHIFT together for about 3 seconds.

Using T-LOW (Tone-Low)

Press PUSH FUNC then T-LOWto turn the high-cut filter on or off. LOW appears when the high-cut filter is on.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents HTX-10 Features Page Manual Conventions FCC InformationContents Introduction to Amateur Radio Page Preparation Attaching the Microphone HolderMounting the Transceiver Page Connecting AN Antenna Page Connecting the Microphone Connecting AN Optional External SpeakerUsing Vehicle Battery Power Frame chassis groundUsing the Transceiver AS a Base Station Page Quick Look AT the Controls Setting Squelch and Receiving OperationTransmitting Page Special Features Using the Special FeaturesUsing Step Using Call Using ScanUsing LCR Last Channel Recall Using M-LOADUsing NB Noise Blanker Using Shift Using T-LOW Tone-LowUsing M-SAVE Memory Save Using Fine ClarifierUsing RF-G RF Gain Using MIC-G Microphone GainTurning the KEY Tone on and OFF Care and Maintenance Troubleshooting Problem Possible Causes RemediesNoise Reduction Replacing the Fuse Page Specifications GeneralTransmitter Page Page RadioShack Division of Tandy Corporation Fort Worth, Texas
Top Page Image Contents