Radio Shack HTX-10 owner manual Using M-SAVE Memory Save, Using Fine Clarifier

Page 25

Using M-SAVE (Memory Save)

Follow these steps to save up to five frequencies into memory channels.

1.Select the desired frequency.

2.Press PUSH FUNC then M-SAVE. S appears.

3.While S appears, press the desired memory channel num- ber. The transceiver stores the frequency you selected into the memory channel you selected.

4.To recall a frequency you stored, see “Using M-LOAD” on Page 23.

Using FINE (Clarifier)

When you listen to an SSB signal, rotate FINE to tune in slightly off-frequency stations or to tune out interference from adjacent channels.

25

Image 25

Contents HTX-10 Features Page FCC Information Manual ConventionsContents Introduction to Amateur Radio Page Attaching the Microphone Holder PreparationMounting the Transceiver Page Connecting AN Antenna Page Connecting AN Optional External Speaker Connecting the MicrophoneFrame chassis ground Using Vehicle Battery PowerUsing the Transceiver AS a Base Station Page Quick Look AT the Controls Operation Setting Squelch and ReceivingTransmitting Page Using the Special Features Special FeaturesUsing Step Using Scan Using CallUsing M-LOAD Using LCR Last Channel RecallUsing NB Noise Blanker Using T-LOW Tone-Low Using ShiftUsing Fine Clarifier Using M-SAVE Memory SaveUsing MIC-G Microphone Gain Using RF-G RF GainTurning the KEY Tone on and OFF Care and Maintenance Problem Possible Causes Remedies TroubleshootingNoise Reduction Replacing the Fuse Page General SpecificationsTransmitter Page Page RadioShack Division of Tandy Corporation Fort Worth, Texas