Radio Shack HTX-10 owner manual Transmitting

Page 18
RF-G

Note: If the transceiver picks up unwanted weak transmis-

sions, rotate slightly counterclockwise to decrease the transceiver’s sensitivity to signals. The transceiver blocks the weak transmissions.

6.Repeatedly press MODE to select the desired band (FM, AM, USB (upper sideband), or LSB (lower sideband)).

7.Rotate TUNE or press UP or DN on the top of the micro- phone to select a frequency.

8.To turn off the transceiver, rotate OFF/VOLUME counterclock- wise until it clicks.

TRANSMITTING

Notes:

Do not attempt to transmit unless you possess a valid ama- teur radio license.

We recommend you try receiving before you transmit.

1.Follow Steps 1–7 in “Setting Squelch and Receiving” on Page 17.

2.Turn MIC-Gfully clockwise.

18

Image 18
Contents HTX-10 Features Page Manual Conventions FCC InformationContents Introduction to Amateur Radio Page Preparation Attaching the Microphone HolderMounting the Transceiver Page Connecting AN Antenna Page Connecting the Microphone Connecting AN Optional External SpeakerUsing Vehicle Battery Power Frame chassis groundUsing the Transceiver AS a Base Station Page Quick Look AT the Controls Setting Squelch and Receiving OperationTransmitting Page Special Features Using the Special FeaturesUsing Step Using Call Using ScanUsing LCR Last Channel Recall Using M-LOADUsing NB Noise Blanker Using Shift Using T-LOW Tone-LowUsing M-SAVE Memory Save Using Fine ClarifierUsing RF-G RF Gain Using MIC-G Microphone GainTurning the KEY Tone on and OFF Care and Maintenance Troubleshooting Problem Possible Causes RemediesNoise Reduction Replacing the Fuse Page Specifications GeneralTransmitter Page Page RadioShack Division of Tandy Corporation Fort Worth, Texas