Radio Shack HTX-10 Using LCR Last Channel Recall, Using M-LOAD, Using NB Noise Blanker

Page 23

Using LCR (Last Channel Recall)

Press LCR to return to the last channel you selected.

Using M-LOAD

You can recall frequencies stored in memory Channels 1–5.

Note: See “Using M-SAVE (Memory Save)” on Page 25 for more information about storing frequencies in memory channels.

To recall a memory channel, press M-LOADso L appears, then, press the desired memory channel number.

Using NB (Noise Blanker)

If the transceiver’s reception is disturbed by interference from electrical noise (such as ignition noise), you can reduce the noise by using the transmitter’s noise blanker feature. To turn on or off the noise blanker, press PUSH FUNC then NB. NB appears while the noise blanker is on.

23

Image 23

Contents HTX-10 Features Page FCC Information Manual ConventionsContents Introduction to Amateur Radio Page Mounting the Transceiver PreparationAttaching the Microphone Holder Page Connecting AN Antenna Page Connecting AN Optional External Speaker Connecting the MicrophoneFrame chassis ground Using Vehicle Battery PowerUsing the Transceiver AS a Base Station Page Quick Look AT the Controls Operation Setting Squelch and ReceivingTransmitting Page Using the Special Features Special FeaturesUsing Step Using Scan Using CallUsing NB Noise Blanker Using LCR Last Channel RecallUsing M-LOAD Using T-LOW Tone-Low Using ShiftUsing Fine Clarifier Using M-SAVE Memory SaveTurning the KEY Tone on and OFF Using RF-G RF GainUsing MIC-G Microphone Gain Care and Maintenance Problem Possible Causes Remedies TroubleshootingNoise Reduction Replacing the Fuse Page General SpecificationsTransmitter Page Page RadioShack Division of Tandy Corporation Fort Worth, Texas