Radio Shack HTX-10 owner manual Specifications, General

Page 32

SPECIFICATIONS

GENERAL

 

 

Frequency Range

28.000 MHz to 29.699 MHz

Tuning Step

1 kHz/10 kHz/100 kHz (selectable)

Frequency Generation

Digital PLL Synthesizer

Antenna Connector

50 ohm coaxial connector

Microphone

Electret condenser type

Operating Temperature

–4° to 122°F (–10° to 55°C)

Power Source

12–16V DC, negative or positive ground

Speaker

8 ohm, 2 watt

Impedance

50 ohm

Dimensions (HWD)

61/16 × 2 3/64 × 9 41/64 inches

 

 

(154 × 52 × 248 mm)

Weight (without batteries)

2.65 lb

 

 

(1.2 kg)

Accessories

Microphone, Microphone Holder,

 

Mounting Hardware, Mounting Bracket,

 

DC Power Cord, Spare Fuse

RECEIVER

 

 

Sensitivity

0.5 V for 10 dB S/N

Audio Output @ 10% THD (External)

2.5 W at 8 ohm

Selectivity

50 dB min

Intermodulation

60 dB min

Distortion

10% max

S/N Ratio

40 dB min

IF Rejection

70 dB or better

32

Image 32
Contents HTX-10 Features Page Manual Conventions FCC InformationContents Introduction to Amateur Radio Page Mounting the Transceiver PreparationAttaching the Microphone Holder Page Connecting AN Antenna Page Connecting the Microphone Connecting AN Optional External SpeakerUsing Vehicle Battery Power Frame chassis groundUsing the Transceiver AS a Base Station Page Quick Look AT the Controls Setting Squelch and Receiving OperationTransmitting Page Special Features Using the Special FeaturesUsing Step Using Call Using ScanUsing NB Noise Blanker Using LCR Last Channel RecallUsing M-LOAD Using Shift Using T-LOW Tone-LowUsing M-SAVE Memory Save Using Fine ClarifierTurning the KEY Tone on and OFF Using RF-G RF GainUsing MIC-G Microphone Gain Care and Maintenance Troubleshooting Problem Possible Causes RemediesNoise Reduction Replacing the Fuse Page Specifications GeneralTransmitter Page Page RadioShack Division of Tandy Corporation Fort Worth, Texas