Installing the Front Cover
1.Insert the plastic tabs on the front cover into the slots on the right of the chassis. Squeeze the front panel and chassis together along the left side until the plastic tabs snap into their slots.
Installing the Hot-swap Bay
1.Tilt the bay into the chassis.
2.Connect the power and data cables to the SCSI backplane.
3.Install and tighten the three screws holding the bay to the chassis.
4.Install the side cover.
Installing an Add-in Board
CAUTIONS
Do not overload the server board by installing
1.Remove side cover.
2.Remove and save the expansion slot screw and cover.
3.Remove
4.Record the type and serial number of the
5.Set jumpers or switches according to the manufacturer’s instructions.
6.Hold board by its top edge or upper corners. Firmly press it into an expansion slot on the server board. The tapered foot of the board retaining bracket must fit into the mating slot in the expansion slot frame.
Install an ISA board component side UP. Install a PCI board component side DOWN.
7.Align the rounded notch in the retaining bracket with the threaded hole in the frame. The bracket fits the space that was occupied by the slot cover.
8.Use the screw removed earlier. Insert it into the threaded hole, and push the rounded notch against the screw. Tighten it firmly to prevent the bracket from interfering with adjacent brackets. Attach cables if necessary.
9.Reinstall the side cover.
Working Inside the System | 33 |