INTEGRATING POUCH ATTACHMENT LADDER SYSTEM AND MOLLE VEST
WARNING: Suitable anchor points must be used as outlined below.
The LP is intended to be secured to a MOLLE vest using the provided buckles. The attachment points secure the LP to the front and back of the MOLLE vest.
The female buckle is designed to mount to the MOLLE vest allowing easy removal of the LP to reconfigure for different mission profiles and allow proper operation of breakaway vests. Ensure the attachment points are accessible, do not interfere with other mounted equipment, and provide a secure fit ensuring the LP is attached as close to the torso as possible.
FIGURE 28 | FIGURE 29 | FIGURE 30 |
1.Lay the MOLLE vest down on a clean flat surface with the back of the vest facing up.
2.Lift up the emergency extraction strap or other anchor point on the back of the vest. Loop the back attachment of the MD3196 LP around the extraction strap or, if no extraction strap is available, around the PALS webbing (Figure 28).
3.Use the buckle to secure and tighten the back attachment strap. The collar of the LP should be located near the neckline (Figure 29).
4.With the LP attached, turn the vest over and lay it flat, with the front of the vest facing up.
5.Position the two front lobes of the LP perpendicular to the webbing across the vest (Figure 30).
WARNING: For optimal flotation, the LP must be secured tightly against the vest.
6.On the
7.Insert the female buckle under the upper row of vest webbing (Figure 31A).
10 |
|
Compact Tactical LP Owners Manual |