To adjust Sensitivity:
1.From the Sonar Page, press MENUENT.
2.The Sensitivity Control Bar appears. Press ↓ to decrease sensitivity; press ↑ to increase sensitivity. When it's set at the desired level, press EXIT. (When you reach the maximum or minimum limit, a tone sounds.)
To turn off HyperScroll:
1.From the Sonar Page, press MENU↓ to PING SPEEDENT.
2.The Ping Speed Control Bar appears. Press ↓ to decrease ping speed to 50 percent. When it's set at the desired level, press EXIT.
When you enable HyperScroll, the width of the FasTrack bar graph display doubles in width at the right side of the screen, giving you a better view of Fastrack's instantaneous sonar returns.
Reset Options
This command is used to reset all features, options and settings to their original factory defaults. This is useful when you have changed several settings and want to return the unit to basic automatic op- eration.
1.Press MENUMENU↓ to SYSTEM SETUP↓ to RESET OPTIONSENT.
2.Press ↑ or ↓ to YESENT.
3.All features and options are returned to the factory default settings.
Sensitivity & Auto Sensitivity
The sensitivity controls the ability of the unit to pick up echoes. A low sensitivity level (from zero to 50 percent) excludes much of the bottom information, fish signals, and other target information. High sensitivity levels let you see this detail, but it can also clutter the screen with many undesired signals. Typically, the best sensitivity level shows a good solid bottom signal with Colorline and some surface clutter.
Automatic Sensitivity
This unit has two sensitivity modes: Automatic and Manual. In auto- matic you can adjust sensitivity up to 100 percent but the unit will limit your minimum setting.
In manual mode, you have complete control over sensitivity, with the ability to set it anywhere from zero to 100 percent.
45