Lowrance electronic Fish Finder manual Transom

Page 15

Transom

Transom

Position transducer mount on transom and mark mounting holes.

Side view shown at left and seen from above at right.

5.Attaching transducer to transom. Remove the transducer from the bracket and re-assemble it with the cable passing through the bracket over the bolt as shown in the following figures.

Route cable over bolt and through bracket. Side view shown at left

and seen from above at right.

Attach the transducer to the transom. Slide the transducer up or down until it's aligned properly with the bottom of the hull as shown in the preceding and following figures. Tighten the bracket's mount- ing screws, sealing them with the sealant/adhesive compound.

Adjust the transducer so that it's parallel to the ground and tighten the nut until it touches the outer washer, then add 1/4 turn. Don't over tighten the lock nut! If you do, the transducer won't "kick-up" if it strikes an object in the water.

Bottom

of

hull

Flat-bottom hull

Deep-"vee" hull

Align transducer centerline with hull bottom and attach to transom.

13

Image 15

Contents M52 Pro Visit our web site Table of Contents Split Zoom Sonar Chart Index Page Sonar sounding GeneralBack-up memory SonarReceiver/antenna How to use this manual typographical conventionsGraphic symbols for Waypoints or event GPSPreparations Transducer InstallationSelecting a Transducer Location Recommended Tools and suppliesHow low should you go? Shoot-thru-hull vs. Transom Mounting Transom Transducer Assembly and Mounting Insert bolt and check transducer position on transom Transom Trolling Motor Bracket Installation Transducer Orientation and Fish Arches Testing Determines Best Location SHOOT-THRU-HULL PreparationHulls With Floatation Materials Transducer location High speed Trolling speed Shoot-thru-hull Installation Power and Cable Connections Page Mounting the Sonar Unit In-Dash or Bracket In-Dash InstallationBracket Installation 107.5 82.7 156 Depress ratchets to Release. Swivel base Installing the Batteries Portable Sonar InstallationPortable transducer installed on boat transom Keyboard Section Basic Sonar OperationMain Menu Sonar Menu Sonar Menu CommandsBasic Sonar Quick Reference Pages Sonar Operations Important Tip Fish Symbols vs. Full Sonar ChartPage ASP Advanced Signal Processing AlarmsPress MENUMENU↓ to ALARMSENT↓ to Sonar Alarmsent Zone AlarmFish Alarm Depth Cursor Chart SpeedDepth Range Manual Depth Range AutomaticDepth Range Upper and Lower Limits FasTrack Fish I.D. Fish Symbols & DepthsGrayline→ FishTrackOverlay Data Ping Speed & HyperScroll Reset Options Sensitivity & Auto SensitivityAutomatic Sensitivity Keel Offset Keel and Waterline OffsetWaterline Offset Sonar Color ModeSonar Chart Display Options Full Sonar ChartSplit Zoom Sonar Chart Digital Data/ChartPro Tips Sonar SimulatorFlasher Zoom Pan Stop ChartSurface Clarity Zoom & Zoom BarUnit operates only in demo mode Unit wont turn onUnit freezes, locks up, or operates erratically Noise No fish arches when the Fish I.D. feature is offMain Menu Section Basic GPS OperationsSatellite Status Sonar PagesNavigation Page Plotter PositionViewing the Plotter Zoom & Cursor Arrow Keys Navigate to Cursor Position on Plotter Selecting Any Plotter Item With the CursorGPS Quick Reference Create a Waypoint Cancel NavigationFind Distance between Points WaypointsPress WPT↓ to Create Newent Delete a Waypoint Find a Waypoint Edit a WaypointSelect a Waypoint Navigate To a Waypoint Set Man Overboard MOB Waypoint Navigate Back to MOB Waypoint TrailsCreating and Saving a Trail Tip Delete a Trail Display a Saved TrailEdit a Trail Name Navigate a Trail Visual TrailingNavigate a Trail forward Page Navigate a Back Trail Delete an Icon IconsCreate Icon on Plotter Create Icon at Current PositionRoutes Navigate to an IconCreate and Save a Route Page Edit a Route Name Delete a RouteNavigate a Route Navigate a Route backward Utilities Page Section System & GPS Setup Options Auto Satellite Search Important Alarm NotesCoordinate System Selection Map Fix Customize Plotter or Navigation Customize Page DisplaysGPS Simulator Customize PositionHide GPS Features Initialize GPSPlotter Auto Zoom Plotter Orientation From the Plotter or Sonar page, press MENU↓ Pop-up Help Position PinningScreen Contrast and Brightness Show Waas Alarm Set LanguageSet Local Time Software Version Information Sounds and Alarm Sound StylesTrack Smoothing Trail OptionsDelete All Trails Main Menu, left, Trails Menu, center, Trail Options, right Trail Visible/Invisible and Other Trail Options Units of MeasureDelete Trail New TrailMain Menu, left, Units of Measure Menu, right Index Page Page 100 Navico Databases License Agreement Databases Limited Warranty Navico Full ONE-YEAR Warranty Not toll-free How to Obtain Service…Accessory Ordering Information for all countries Visit our web site