Preface
The information in this manual is based on current industry sources and believed by the author to be correct and as complete as possible at the time of printing. It is possible that later changes have been made by the manufacturers of ACS equipment and are not included in this publication. Although every effort has been made to insure total accuracy, ACS cannot assume any liabilities for omission, errors or changes that have occurred in the production of this manual.
It is not possible to anticipate all possible conditions in which this machinery may be utilized, maintained or serviced. It is not possible to provide cautions for all possible hazards. Operators and maintenance personnel should use standard and accepted operating procedures and precautions. ACS accepts no responsibility for the damages resulting from the utilization of the information in this manual. Please note that this is a service manual; it is not appropriate for use by system operators.
Copyright
The material in this publication was compiled for the use at ACS. No part of this manual may be reproduced, stored, transmitted or distributed without the prior written consent of ACS.
© 2003
Revised October 21, 2003
Overview
The A3 System Management Software program is a Windows based program that allows you to control and monitor up to 1000 ACS devices. Currently you can use A3 with the following devices:
•OS Blender (AEC AB controls)
•OA Blender (AEC AB controls)
•Sterling SGB Blenders (Mitsubishi Controls)
•Older OS Blender (HydReclaim Proprietary Controls)
•Older OA Blender (HydReclaim Proprietary Controls)
•Older OL Blender (HydReclaim Proprietary Controls)
•Older OFC Weigh Hopper (HydReclaim Proprietary Controls)
Page 4