Furuno FR-2115-B installation manual Mounting the monitor

1.3.2 Mounting the monitor

1.Drill four holes of 12 mm in diameter in the mounting location, referring to the outline drawing for mounting dimensions.

2.Unfasten two M4X10 screws to dismount the monitor cover.

3.Unfasten two sets of M10 bolts, plain washers and spring washers at the front of the monitor to separate the monitor from the mounting base.

4.Pull the monitor forward about 4 centimeters and then lift if from the mounting base.

5.Fasten the mounting base to the mounting location with M10 bolts, nuts and washers (local supply), using the pipe box wrench supplied. Make sure there is 3mm protrusion under the nut.

6.Lay the monitor on the top of the mounting base, making sure the rear pin on the monitor is mated with the slit in the mounting base. Fix the mounting base with the two sets of bolts, and washers unfastened at step 3.

7. Fasten the monitor cover.

Plain Washer, M10, 2 pcs.

Spring Washer, M10, 2 pcs.

Hex Bolt M10X30, 2 pcs.

Monitor Cover

Pan-Head Screw

M4X10, 2 pcs.

Mounting Base

Hex Bolt. (M10)

More than 3mm

Figure 1-7 Monitor

Pin

Hex Bolt

M10, 4 pcs.

Washer

Slit

Mounting Base

1-10