Furuno FR-2115-B Performance Monitor PM-30, Necessary parts PM-30 and OP03-150 Code no

4.4Performance Monitor PM-30

Necessary parts: PM-30 and OP03-150 (Code no. 008-485-490)

Name	Type	Code No.	Qty
PM-IN Board	03P9225	008-487-620	1
Pan-head Screw B	M3X8 C2700W	000-881-404	3
Connector Assy.	VH3P-L300-AA	000-141-014	2

1.Open the processor unit. Unfasten three screws to remove the RGB Board together with its mounting plate. Unfasten the monitor cable at the RGB Board. (See Figure 4-9 on page 4-10 for location.)

2.Fasten the PM Board 03P9225 to the location shown below with three M3X8 pan-head screws.

J403

PM Board 03P9225

J401

J411J402

Figure 4-13 Processor unit, inside view

3.Connect J411 to J401 on the PM Board.

4.Connect two connector assemblies (VH3P-L300-AA) to J402 and J403.

5.Solder the other end of the connector assemblies with external cables, one from ship's mains and one from the PM-30.

6.Fasten the RBG board and its mounting plate and connect the monitor cable. Close the processor unit.

4-13