Furuno FR-2115-B installation manual Do not open the equipment

WARNING

	Do not open the equipment
	unless totally familiar with
	electrical circuits and
	service manual.
ELECTRICAL	Only qualified personnel
	should work inside the
SHOCK
HAZARD	equipment.
	Wear a safety belt and hard
	hat when working on the
	antenna unit.

Serious injury or death can result if someone falls from the radar antenna mast.

Construct a suitable service platform from which to install the antenna unit.

Serious injury or death can result if some- one falls from the radar antenna mast.

Turn off the power at the mains switch- board before beginning the installation.

Fire, electrical shock or serious injury can result if the power is left on or is applied while the equipment is being installed.

Do not install the display unit where it may get wet from rain or water splash.

Water in the display unit can result in fire, electrical shock or equipment damage.

WARNING

Be sure that the power supply is compatible with the voltage rating of the equipment.

Connection of an incorrect power supply can cause fire or equipment damage. The voltage rating of the equipment appears on the label above the power connector.

Use only the specified power cable.

Fire or equipment damage can result if a different cable is used.

CAUTION

Ground the equipment to prevent electrical shock and mutual interference.

Observe the following compass safe distances to prevent interference to a magnetic compass:

	Standard	Steering
	compass	compass
Processor	1.70 m	0.90 m
unit
Antenna	1.70 m	0.90 m
unit
(FR-2115-B)
Antenna	2.10 m	1.20 m
unit
(FR-2125-B)

ii