2.3Monitor
2.3.1 Connection of monitor cable inside processor unit
The monitor cable (a monitor cable comes with FURUNO-supplied monitor) runs between the RGB Board (inside the processor unit) and the monitor. Route it inside the processor unit as below. Connect the cable to J2 on the RGB Board. If a converter adaptor is used it may be necessary to route the cable differently than shown. In any case be sure the cable does not touch the TX-HV Board.
EXPLODED VIEW
TX-HV Board (Underneath the plate)
Locking Wire Saddle
Locking Wire Saddle LWS-2H
45° 
with M3X10 Pan-head Screw
Cable inside Locking Wire |
Saddle | |
| Locking Wire |
Cable | Saddle |
Figure 2-11 Processor unit, inside view
