Furuno FR-2115-B installation manual INT Board Gyro Converter Board J446 4P J7 5P J465 6P J1 14P

4.Connect the GYRO CONVERTER Board to the INT Board (cables supplied with GC-8) as shown below.

INT Board GYRO CONVERTER Board

J446 (4P) J7 (5P)

J465 (6P) J1 (14P)

J5

To gyro

J4

J446 J7

J1

J465

Fix cable to chassis

INT BOARDwith cable tie. 03P9252

GYRO CONVERTER BOARD 64P1106

Figure 4-2 Processor unit, inside view

5.Confirm gyrocompass specifications and set the DIP switches and jumper wires on the GYRO CONVERTER Board according to the gyrocompass connected:

Setting jumper wires and DIP switches by gyrocompass specifications: page 4-4

Setting jumper wires and DIP switches by make and model of gyrocompass: page 4-5

Location of jumper wires and DIP switches: page 4-6

6.Solder the gyrocompass cable to the VH connector assemblies (supplied).

7.Attach instruction label (supplied) to shield cover for the INT and GYRO CONVERTER boards.

8.Close both the INT Board cover and the processor unit cover.

9.Turn the power off and on again to reset the CPU.

4-2