Furuno FR-2115-B AC Power Specification of Processor Unit, How to attach NH connector

How to attach NH connector

HOW TO ATTACH NH CONNECTOR TO SIGNAL CABLE

NH connector wire

Shrink tubing

NH connector	20mm
housing
1) Insert NH connector	2) Cut shrink tubing
wire into NH connector	in 20 mm lengths and
housing.	slip onto each wire.

Solder
3) Solder connector	4) Heat shrink
to signal cable.	tubing with solder-
	ing iron.

Figure 2-15 How to attach NH connector

2.6AC Power Specification of Processor Unit

For 100 VAC or 220 VAC power, add or delete jumper wires on the PTU Board and change the power fuses inside the processor unit as shown in the table below according to ship's mains. The figure below shows the location of the power fuses and the jumper wires on the PTU Board.

Table 2-2 Jumper wire setting on the PTU board, fuse rating and power specification

PCB	Power Spec.	Antenna		JP1	JP2	JP3	JP4	JP91	JP92	Power
	(VAC)	rpm								Fuse
03P9245A	100/110/115	24 rpm		YES	YES	YES	NO	NO	NO	10A
03P9245D	220/230	24 rpm		NO	NO	NO	YES	NO	NO	5A
	PTUBoard		Jumper wire to use:
			JP1: 0.8 dia. gilded wire
			JP2, JP3, JP4, JP91, JP92: type ERD-S2TCOV

JP1

Fuse

JP2

JP92

JP3

JP4

JP91

03P9245

PTU Board

Figure 2-16 Processor unit, inside view

2-13