Sterling SSV 05 operating instructions SSV Electrical connection

Page 19

SSV 05

2.5. Electrical connection

Observe the regulations of the local electricity board.

The operating voltage is 230 V, AC, PE, 50/60 Hz.

Special voltages available on request.

The connected load is approx. 15 W.

The connection takes place by means of a mains connector.

Aseparate protection of the socket is not necessary. Connect the plug of the probe cable to the control unit. Plug the mains connector into a corresponding socket.

SM4-600

Installation instructions 18

Image 19

Contents Sterling Material Processing Operating Instructions Single Conveyor Unit SSVParts and Service Department SSV Sterling Material Processing Technical serviceTelephone 800 Edition 08/99 SSV Table of contents SSV Technical data Safety instructions Safety instructionsSSV SSV Explanations and information SSV For your safety SSV SSV SSV For the safety of the units Installation instructions SSV General information SSV Installing the conveyor hopper SSV Installing the control and maintenance unit SSV Connecting the compressed-air supply SSV Electrical connection Functional description SSV Method of functioning Control and maintenance unitSet-up Filling level too high Basic setting of the filling level in the conveyor hopperSSV Preparations Filling level too lowSet-up Maintenance SSV SSV Maintenance intervals Disassembly SSV Cleaning/replacing the filter cartridgeAdjusting the level probe SSV AssemblyTest steps SSV Trouble-shooting Problem RemedyTechnical data SSV Dimension sheet SSV Spare parts list SSV Pos ID-No Designation