Sterling SSV 05 operating instructions Maintenance, Ssv

Page 25

SSV 05

5. Maintenance

»

SM4-600

This chapter is intended for persons with skills in electrical and mechanical areas due to their training, experience and received instructions.

Personnel using the instructions in this chapter must be in- structed of the regulations for the prevention of accidents, the operating conditions and safety regulations and their implemen- tation.

Ensure in each case that the personnel are informed accord- ingly.

For maintenance work taking place at heights of over approx. 6 feet (1829)mm, use only ladders or similar equipment and work- ing platforms intended for this purpose. At greater heights, the proper equipment for protection against falling must be worn.

Use only suitable lifting gear which is in proper working order and load suspension devices with sufficient carrying capacity. Do not stand or work under suspended loads!

Ensure that the electric motors/switch cabinets are sufficiently protected against moisture.

Use only suitable workshop equipment.

Before starting maintenance work, appoint a supervisor.

Inform the responsible personnel before maintenance work on the system is started.

Never operate the equipment when partially dismantled.

All maintenance and repair work not described in this chapter may only be carried out by Sterlingservice personnel or authorized personnel (appointed by Sterling).

Maintenance 24

Image 25
Contents Sterling Material Processing Operating Instructions Single Conveyor Unit SSVParts and Service Department SSV Sterling Material Processing Technical serviceTelephone 800 Edition 08/99 SSV Table of contents SSV Technical data Safety instructions Safety instructionsSSV SSV Explanations and information SSV For your safety SSV SSV SSV For the safety of the units Installation instructions SSV General information SSV Installing the conveyor hopper SSV Installing the control and maintenance unit SSV Connecting the compressed-air supply SSV Electrical connection Functional description SSV Method of functioning Control and maintenance unitSet-up SSV Preparations Basic setting of the filling level in the conveyor hopperFilling level too low Filling level too highSet-up Maintenance SSV SSV Maintenance intervals Disassembly SSV Cleaning/replacing the filter cartridgeAdjusting the level probe SSV AssemblyTest steps SSV Trouble-shooting Problem RemedyTechnical data SSV Dimension sheet SSV Spare parts list SSV Pos ID-No Designation