Sterling SSV 05 operating instructions SSV Installing the conveyor hopper

Page 16

SSV 05

2.2. Installing the conveyor hopper

The single conveyor unit is not sensitive to shocks and can be installed directly on the processing machine.

Make sure that all connections are tight so that the conveying performance is not impaired.

The conveyor hopper is equipped with a universal flange.

Depending on the position, drill the holes for fastening the conveyor hopper to the processing machine.

Mount the conveyor hopper on the processing machine.

Install the supply hose on the conveyor hopper and on the injector tube by means of the hose clamps which are part of the supply.

F

Note that the hopper may not touch any other component.

SM4-600

Installation instructions 15

Image 16
Contents Operating Instructions Single Conveyor Unit SSV Sterling Material ProcessingParts and Service Department SSV Sterling Material Processing Technical serviceTelephone 800 Edition 08/99 SSV Table of contents SSV Technical data Safety instructions Safety instructionsSSV SSV Explanations and information SSV For your safety SSV SSV SSV For the safety of the units Installation instructions SSV General information SSV Installing the conveyor hopper SSV Installing the control and maintenance unit SSV Connecting the compressed-air supply SSV Electrical connection Functional description Control and maintenance unit SSV Method of functioningSet-up Basic setting of the filling level in the conveyor hopper SSV PreparationsFilling level too low Filling level too highSet-up Maintenance SSV SSV Maintenance intervals SSV Cleaning/replacing the filter cartridge DisassemblySSV Assembly Adjusting the level probeSSV Trouble-shooting Problem Remedy Test stepsTechnical data SSV Dimension sheet SSV Spare parts list SSV Pos ID-No Designation