Multiquip GB114BS/BP manual Pole Setup

SETUP

NOTICE

The pole clamp assembly used in this setup procedure is a dual type clamp. One side of the clamp is for the attachment of the main pole of the lighting system.The other side of the clamp is used for the attachment of a support pole that is usually connected to a piece of equipment such as a paver.

POLE SETUP

Refer to Figure 6 for the following procedure.

1.Remove the offset pole (B) from the shipping container.

2.Attached to the offset pole is a 17/19 mm open-end wrench (C). Remove the wingnut (D) securing the wrench to the offset pole and remove wrench.

3.Reinsert wingnut and washer back into offset pole so they will not get lost or misplaced.

4.Remove the two pole clamp assemblies (A) from the shipping container. Attach one pole clamp assembly

(E) to the main pole (F) about 3 inches (76.2 mm) down from the main pole extension clamp. Using supplied 19 mm wrench, tighten locknut on the pole clamp assembly securely.

5.Attach the other pole clamp assembly (G) to the main pole (F) about 7.0 in. (140 mm.) down from the previous attached pole clamp assembly (E). Using the 19 mm wrench, tighten locknut on the pole clamp assembly securely.

6.To attach main pole (F) to equipment support pole (I), swing open adjustable tension plate (H) on clamp so that it can accomodate the diameter of the equipment support pole. Insert equipment support pole (I) through the two equipment support pole clamp assemblies as shown in Figure 6.

7.Once the equipment support pole (I) has been seated properly, move adjustment bolt and locknut (J) into locking position. Use the supplied 17 mm wrench, to tighten locknuts (J) on both clamps securely.

8.Place offset pole (B) with adapter clamp (K) on top of adjustable extension pole (L). Make sure that offset pole has been seated correctly.

9.Using 17 mm wrench, tighten both bolts (M) on the offset adapter clamp (K) securely.

10.Place lamp assembly (N) onto offset pole (B). Tighten T-handle bolt (O) securely.

			N
			LAMP
			ASSEMBLY
				B
				OFFSET
				POLE
			O		K
		T-HANDLE		OFFSET
P				ADAPTER
				CLAMP
BALLOON			C
POWER				M
CABLE
	REMOVE			L
	WRENCH		WINGNUT	ADJUSTABLE
			D	EXTENSION
				POLE
EQUIPMENT		J		EXTENSION
		ADJUSTMENT		CLAMP		Q
SUPPORT				BOLT
		BOLT AND
POLE CLAMP
		LOCKNUT
						3.0 IN.
LOCKNUT				(76.2 MM
			E
MAIN POLE		H	POLE
CLAMP
	TENSION		CLAMP
ADJUSTABLE			ASSY.
		PLATE
CHANNEL
			MAIN
			POLE			7.0 IN.
			F
				(140 MM
POLE
CLAMP			G
ASSEMBLY
A			POLE
			CLAMP
			ASSY.

EQUIPMENT

SUPPORT

POLE

I

Figure 6. Offset Pole Assembly

PAGE 16 — GB114BS/BP GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #3 (01/06/09)