Mounting procedure
1.Drill four holes of 12 mm in diameter in the mounting location, referring to the outline drawing for mounting dimensions.
2.Unfasten two M4X10 screws to dismount the front cover.
3.Unfasten two sets of M10 bolts, plain washers and spring washers to separate the monitor from the mounting base.
4.Pull the monitor forward about four centimeters and then lift it to separate it from the mounting base.
5.Fasten the mounting base to the mounting location with M10 bolts, nuts and washers (local supply).
6.Lay the monitor on the top of the mounting base, making sure the rear pin on the monitor is mated to the slit in the mounting base. Fix the monitor to the mounting base with the two sets of bolts, nuts and washers unfastened at step 3.
7.Close the front cover.
Plain Washer, M10, 2 pcs.
Spring Washer, M10, 2 pcs.
Hex Bolt M10X30, 2 pcs.
Front Cover
M4X10, 2 pcs.
Pin
Hex Bolt
M10X30, 4 pcs.
Washer
Slit
Mounting Base