Furuno FSV-24S installation manual How to connect cables to the monitor unit

2.3.3How to connect cables to the monitor unit

Connect the monitor cable and control cable to the monitor (FURUNO-supplied monitor) unit as below.

1.Unfasten four screws (M4x10) at the rear of the monitor to loosen the cable cover.

2.Lift and pull the cable cover to remove it.

3.Unfasten two screws (M4x10) to remove the clamp cover.

4.Lay the monitor and control cables on the clamp, and then reattach the clamp plate to fix cables.

5.Connect eight connectors referring to the instruction sticker by the connector board.

6.Reattach the cable cover.

Connector board

CN-A306 CN-A305 CN-A304

3			B	2		G	1 R
CN-A308 CN-A307
5		H		4		V	CN-A302
CN-A301 CN-A303								PROCESSOR UNIT
	CONTROL UNIT				PROCESSOR	UNIT

Monitor cable

Control cable

Clamp

Cable cover

Monitor unit, rear view

2-7