Furuno FSV-24S installation manual Check List

Check List		Ship Name		Date	/	/	Location
SCANNING		TYPE	FSV-24						RESULT
SONAR
S/N		Monitor unit (FSV-2400)					Options
		Control unit (FSV-2401)					CS-120A
		Processor unit (FSV-2402)					VI-1100A
		Transceiver unit (FSV-241E)					CS-170
		Power supply unit (FSV-242)					FSV-2451(5m),FSV2452(15m)
		Hull unit (FSV-243E/244E )
Reference
Frequency		24KHz
Transducer location
Note:
NO	CHECK ITEMS			CONTENT					RESULT	DATA
1	Unit installation		All units are installed according to installation					Good/No Good
			manual.
2	Grounding		Copper plate should be connected for the					Good/No Good		Sheet 1
			following units.
			1.Power supply unit
			2.Transceiver unit
			3.Junction box(Option)
			IV-8sq is connected for the following units.
			1.Raise/lower box
			2.Processor unit
			3.Monitor unit
3	Connection		Check the connection between each unit.					Good/No Good		Sheet 1
			1.Transducer-Transceiver unit
			2.Transceiver unit-Processor unit
			3.Processor unit-Monitor unit
			4.Monitor unit-Control unit
			5.Processor unit- Other equipments
			6.Ship’s mains-Power supply unit
			7.Ship’s mains-Hull unit
			8.Ship’s mains-Processor unit
4	Power Supply		Check ship’s mains voltage for following units.					Good/No Good		Sheet 1
	(Ship’s mains)		1.Power supply unit
			2.Raise/lower motor line
			Check whether led of phase detector is light or
			not.
			The 3 phase line must be changed if led is light.
			3.Processor unit
5	Output power		Check output power and +B voltage.					Good/No Good		Fig1
6	Test		Check the following tests.					Good/No Good		Sheet2
			Board test/Panel test/RX test/Channel							Installation
			test1/Channel test2/Noise test							manual
7	Setting		Check the user program setting.							Sheet3
8	Operation check		Check pictures after turning on the power.					Good/No Good

AP-1