Furuno FSV-24S installation manual Raise/Lower Control Box

2.7.2Raise/Lower Control Box

Connect power cable (3φ) and the transceiver unit cable (10S2078) as shown below.

CN-C101
Connect the transceiver
cable (10S2078) to here.
	Cable TPYCY-4
	Sheath
TB-C101	Armor
Connect the power cable TPYCY-4
(Japan Industrial Standard) or the
equivalent to this board.	Vinyl
LED (Red)	sheath
For detection of phase reversal on	Conductor
3 phase power cable	S = 4 mm 2
	∅ = 2.55 mm

Confirm LED after completing the installation. The LED lights (in red) if power connection is correct. If it is off, turn off power from the mains switchboard, check the cable connection and recheck the LED. The hull unit does not work if this connection is wrong.

Normal phase: LED lights (in red).

Phase reversal: LED does not light.

Power cable (3φ) TPYCY-4

Cable from transceiver unit 10S2078

Raise/lower control box, cover removed

2-19