Solid State Logic 82S6PC1010C manual Appendix F Additional Information for Installing Stageboxes

Appendix F – Stagebox Installation

Appendix F: Additional Information for Installing Stageboxes

When positioning and installing C-SB the following rules must be followed:

•Unobstructed airflow at front and rear.

•No obstruction to airflow, horizontal or vertical, within 300mm in front, above and below both the front and rear panels.

•Ambient temperature no more than 30˚C measured at the air intake (lower front opening) or just below the rear heatsink.

•Microphone cables must not obstruct the air intake. To help ensure this, a cable guide is provided down the sides of the rack.

Design Requirements for a Flightcase

If a Stagebox is to be installed into a flight case the following requirements, in addition to those above, must be met to ensure adequate passive cooling – otherwise user must install a ‘forced-ventilation kit’.

•Both front and rear covers must be completely removed during operation.

•The front and rear covers must be deep enough to ensure that the front and rear faces of Stagebox are flush with front and rear of the open flight case.

Page 67