Solid State Logic 82S6PC1010C manual Talkback and Oscillator, Talkback Connections

Section 5 Installation Wiring

Talkback and Oscillator

Talkback Connections

The C100 console contains a built-in talkback microphone and amplifier. In addition, a second input is available for con nection t o an exter nal dynamic micropho ne. This input is m ixed with the internal T/B mic and the combined signal is available via an XLR connector on the audio interface panel beneath the console. This signal should be c onnected t o an an alogue in put circuit in t he Centur i pro cessor. The c ircuit chosen can then be assigned as the talkback source via the console’s routing.

The gai n o f each m ic s ignal c an b e indepen dently adjust ed. Access t o the trim controls is from beneath the console on the console interface panel.

The external mic input is via a 3-pin XLR female labelled ‘Ext T/B Mic In’. The mixed T/B output is via a 3-pin XLR Male labelled ‘Talkback Output’. See Appendix C for connector pinouts.

Oscillator Connections

The C100 sy stem includes an inbuilt software oscillator. This can be assigned t o any relevant output without additional cabling.

Alternatively, an external oscillator (either analogue or digital, mono or stereo) may be used. In this instance one or two circuits should be allocated on an input card, these can then be assigned in software.

Page 43