Line 6 POD X3 Family manual Dynamics Stomp Boxes

Page 61

Reference:Tweaking Tones

Dynamics Stomp Boxes

Sust – varies the compression threshold.

Level – adjusts the overall level.

Sens – varies the effect’s response to your playing.

Amount – on Vetta Juice, varies the ratio of compression.

Ramp – for Swell effects, sets the time it takes for your sound to “ramp” from quiet to loud.

Depth – for Swell effects, sets how much the volume of your attacks is reduced.

Frequency – on De-Essers, chooses the frequency that’s targeted for reduction. 5•5 Amount – on De-Essers, the amount of reduction applied to Frequency.

Filter Stomp Boxes

Sens – varies the filter’s response to your playing.

Q – adjusts the filter’s width.

Decay – sets how fast (or slow) the effect trails off.

Wave – allows you to choose from among the effect’s available waveforms.

Mix – controls the ratio of wet (effected) to dry (non-effected) sound that is heard. -1 Oct – controls how loud you want the “one octave down” waveform.

-2 Oct – controls how loud you want the “two octaves down” waveform.

Filter – sets the corner frequency of the filter’s low-pass filter; frequencies above this frequency are cut.

INTVL1 – chooses the first pitch interval of your original note played. INTVL2 – chooses the second pitch interval of your original note played.

Image 61
Contents POD X3 Family Serial no Please Note Table of Contents Example Setups Reference Configuration & SetupAppendix a Signal Flow USB & Computer SoftwarePage Tutorial POD X3 Live for Guitar Tweak the Amp Tone Controls Pick a Stomp Model and tweak it Show the Delay settings Tweak the EQ Turn both Tones on at once Select and Tweak Tone 1/Tone Tweak combined volume of Tone 1 + Tone Save For Guitar Tutorial POD X3 & POD X3 ProTurn on the Amp Model DOUBLE-PRESS to Adjust Tap delay tempo Press down To select Lower row Tap is set to Preset loads into Tone These knobs and buttons control only one Tone at a time POD Controls & ConnectionsControls & Connections Controls & Connections Tempo that you’ve tapped Input 2/Microphone In and Trim plug in your microphone here Controls & Connections Join the Club POD X3 Live Controls & Connections 310 Controls & Connections Controls & Connections 313 314 315 316 POD X3 ProControls & Connections 318 319 320 321 322 323 Page Home Getting Around, Tones & TunerBlock not selectedBlock selected Turn to tweak lower row settings Dual Tone Concept Hold Tone Volume Controls Preset Folders You can also choose to recall only Tone Recalling PresetsOr only Tone Recalling User Presets on POD X3 LiveSaving Tones Locking Tone410 440HZ Tuner411 Page Amp + Cab Reference Tweaking TonesGuitar Amp Model Tone Controls Tone ControlsBass Amp Model Tone Controls Distortion Stomp Boxes Stomp BoxesDynamics Stomp Boxes ReferenceTweaking Tones Modulation Effects ReferenceTweaking Tones Delay 510 Reverb Gate 513 Compressor514 515 Wah516 Volume PedalMIX Effects Loop POD X3 Live & POD X3 Pro onlyPage Inputs Reference Configuration & SetupOutputs Reference Configuration & Setup Outputs Page 2 Studio/Direct Mix System System Page 1 Pedal and other settingsSystem Page 2 Pedal and other settings Commands Page Mono or Stereo Recording or Direct to Mixer/PA Example SetupsRecording Tone 1 & 2 to Separate Mono Tracks Feed Two Guitar Amps, One for Tone 1 and One for Tone Feed One Guitar AmpFeed Two Guitar Amps, One Wet and One Dry Example Setups Example Setups Example Setups Page Updating POD X3, POD X3 Live or POD X3 Pro’s Firmware USB & Computer SoftwareSetting Up For USB Recording USB Sends When Operating In Stereo Tone Mode Page Ignal PpendixFlow POD X3 Live POD X3 Pro