Line 6 POD X3 Family manual Outputs

Page 76

Reference: Configuration & Setup

•Analog Input Restriction: POD X3 Pro does not allow simultaneous input from more than one analog input per Channel Strip. For example, if Gtr 1 is selected as input for Tone 1, no combination of a Tone 1 analog input such as Gtr 1, Mic 1, Line 1, Gtr 1+Gtr 2, Gtr 1+Variax or Gtr 1+Gtr 2+Variax will be available for Tone 2.

Digital (POD X3 Pro only) – select either S/PDIF or AES/EBU for digital input.

•Digital Input Restriction: Only one digital input can be active at once. For example, if Variax is selected as an input, AES/EBU and S/PDIF will not be available.

Variax (POD X3 Live and POD X3 Pro only) – you have two choices here:

•Enable Global Control – the X3 Live or Pro will control your Variax, and the lower half of the LCD will display its currently selected Model and other parameters.

•Disable Global Control – when global control is disabled, your Variax will be heard but it won’t respond to patch changes. The lower half of the LCD will be blank.

Outputs

6•2	Pressing the Outputs button gets you to the first of two Outputs pages:

Press the 4-way Nav Left and Right to move between page 1 and page 2.

Outputs Page 1: 1/4-inch Outputs – this is where you set up the 1/4-inch outputs on POD X3, POD X3 Live and POD X3 Pro.

Mode – turn this knob to pick from:

“Studio” Modes (for direct connections to a mixer, recorder, PA, or headphones)

•Match Studio/Direct – the 1/4-inch jacks output the Studio/Direct Mode mix set on

Image 76

Contents POD X3 Family Serial no Please Note Table of Contents Reference Configuration & Setup Example SetupsAppendix a Signal Flow USB & Computer SoftwarePage Tutorial POD X3 Live for Guitar Tweak the Amp Tone Controls Pick a Stomp Model and tweak it Show the Delay settings Tweak the EQ Turn both Tones on at once Select and Tweak Tone 1/Tone Tweak combined volume of Tone 1 + Tone Save Tutorial POD X3 & POD X3 Pro For GuitarTurn on the Amp Model DOUBLE-PRESS to Adjust Tap delay tempo Press down To select Lower row Tap is set to Preset loads into Tone These knobs and buttons control only one Tone at a time Controls & Connections PODControls & Connections Controls & Connections Tempo that you’ve tapped Input 2/Microphone In and Trim plug in your microphone here Controls & Connections Join the Club POD X3 Live Controls & Connections 310 Controls & Connections Controls & Connections 313 314 315 POD X3 Pro 316Controls & Connections 318 319 320 321 322 323 Page Getting Around, Tones & Tuner HomeBlock not selectedBlock selected Turn to tweak lower row settings Dual Tone Concept Hold Tone Volume Controls Preset Folders Recalling Presets You can also choose to recall only ToneRecalling User Presets on POD X3 Live Or only ToneSaving Tones Locking Tone410 440HZ Tuner411 Page Reference Tweaking Tones Amp + CabTone Controls Guitar Amp Model Tone ControlsBass Amp Model Tone Controls Stomp Boxes Distortion Stomp BoxesDynamics Stomp Boxes ReferenceTweaking Tones Modulation Effects ReferenceTweaking Tones Delay 510 Reverb Gate Compressor 513514 Wah 515Volume Pedal 516Effects Loop POD X3 Live & POD X3 Pro only MIXPage Reference Configuration & Setup InputsOutputs Reference Configuration & Setup Outputs Page 2 Studio/Direct Mix System Page 1 Pedal and other settings SystemSystem Page 2 Pedal and other settings Commands Page Example Setups Mono or Stereo Recording or Direct to Mixer/PARecording Tone 1 & 2 to Separate Mono Tracks Feed One Guitar Amp Feed Two Guitar Amps, One for Tone 1 and One for ToneFeed Two Guitar Amps, One Wet and One Dry Example Setups Example Setups Example Setups Page USB & Computer Software Updating POD X3, POD X3 Live or POD X3 Pro’s FirmwareSetting Up For USB Recording USB Sends When Operating In Stereo Tone Mode Page Ignal PpendixFlow POD X3 Live POD X3 Pro