Line 6 POD X3 Family manual Reference Tweaking Tones, Amp + Cab

Page 57

Reference:Tweaking Tones

Reference: Tweaking Tones

Amp + Cab

5•1

Type – turn this knob to select Guitar Amp Models, Bass Amp Models or Pre-Amp type Models.

Select Knob – once the Type has been selected, turn the Select Knob to pick an Amp Model. The Model names will appear at the top of the display.

Cab – spins through the available Cabinet Models. The available cabs will change depending on the Amp Model that is chosen.

Mic – changes the microphone selection.

Room - adjusts the amount of “room tone” in your sound. Low settings give you the sound of moving the virtual microphone closer to the virtual cabinet (you’ll hear only a small amount of the early reflections caused by the sound echoing in the room). Higher settings increase the early reflections, as if you moved the mic farther from the cabinet.

Byp Vol - sets the Bypass Volume, the volume that this tone will be set to when the Amp+Cab block is off. It doesn’t affect the volume you hear with the Amp+Cab block on.

Image 57

Contents POD X3 Family Serial no Please Note Table of Contents Example Setups Reference Configuration & SetupAppendix a Signal Flow USB & Computer SoftwarePage Tutorial POD X3 Live for Guitar Tweak the Amp Tone Controls Pick a Stomp Model and tweak it Show the Delay settings Tweak the EQ Turn both Tones on at once Select and Tweak Tone 1/Tone Tweak combined volume of Tone 1 + Tone Save For Guitar Tutorial POD X3 & POD X3 ProTurn on the Amp Model DOUBLE-PRESS to Adjust Tap delay tempo Press down To select Lower row Tap is set to Preset loads into Tone These knobs and buttons control only one Tone at a time POD Controls & ConnectionsControls & Connections Controls & Connections Tempo that you’ve tapped Input 2/Microphone In and Trim plug in your microphone here Controls & Connections Join the Club POD X3 Live Controls & Connections 310 Controls & Connections Controls & Connections 313 314 315 316 POD X3 ProControls & Connections 318 319 320 321 322 323 Page Home Getting Around, Tones & TunerBlock not selectedBlock selected Turn to tweak lower row settings Dual Tone Concept Hold Tone Volume Controls Preset Folders You can also choose to recall only Tone Recalling PresetsOr only Tone Recalling User Presets on POD X3 LiveLocking Tone Saving Tones410 Tuner 440HZ411 Page Amp + Cab Reference Tweaking TonesGuitar Amp Model Tone Controls Tone ControlsBass Amp Model Tone Controls Distortion Stomp Boxes Stomp BoxesDynamics Stomp Boxes ReferenceTweaking Tones Modulation Effects ReferenceTweaking Tones Delay 510 Reverb Gate 513 Compressor514 515 Wah516 Volume PedalMIX Effects Loop POD X3 Live & POD X3 Pro onlyPage Inputs Reference Configuration & SetupOutputs Reference Configuration & Setup Outputs Page 2 Studio/Direct Mix System System Page 1 Pedal and other settingsSystem Page 2 Pedal and other settings Commands Page Mono or Stereo Recording or Direct to Mixer/PA Example SetupsRecording Tone 1 & 2 to Separate Mono Tracks Feed Two Guitar Amps, One for Tone 1 and One for Tone Feed One Guitar AmpFeed Two Guitar Amps, One Wet and One Dry Example Setups Example Setups Example Setups Page Updating POD X3, POD X3 Live or POD X3 Pro’s Firmware USB & Computer SoftwareSetting Up For USB Recording USB Sends When Operating In Stereo Tone Mode Page Ppendix IgnalFlow POD X3 Live POD X3 Pro