Line 6 POD X3 Family manual 510

Page 66

Reference:Tweaking Tones

Drive – for Tape Delay models, adds some tube warmth.

Flut – for Tape Delay models, adjusts wow-and-flutter, that unique sound of a slipping, dirty capstan.

Heads – for some Tape Delays, enables you to choose from the available combinations of the model’s virtual tape heads.

Speed – is the speed of the modulation for a modulated Delay Model.

L-Fdbk – for Stereo Delays, controls the left-channel feedback.

R-Fdbk – for Stereo Delays, controls the right-channel feedback.

 

Offset – for Stereo Delays, sets the time for the right side delay line, as a percentage

5•10

of the left delay’s Time setting.

Spread – for Stereo Delays, sets the stereo spread of the delays from mono to hard- panned left and right.

Tone – overall tone control.

Bits – for Low Rez Delay, lets you adjust the delay anywhere from 12 bit resolution down to as few as 4 truly nasty bits. Bear in mind that as you turn the knob clockwise, you’re reducing the bit resolution, so maximum bit reduction is achieved when the knob is all the way up (think of it as a more control for how many less bits you want). Your direct sound, of course, stays full resolution.

Page 65 Page 67
Image 66
Page 65 Page 67
Contents POD X3 Family Serial no Please Note Table of Contents Appendix a Signal Flow Reference Configuration & SetupExample Setups USB & Computer SoftwarePage Tutorial POD X3 Live for Guitar Tweak the Amp Tone Controls Pick a Stomp Model and tweak it Show the Delay settings Tweak the EQ Turn both Tones on at once Select and Tweak Tone 1/Tone Tweak combined volume of Tone 1 + Tone Save Tutorial POD X3 & POD X3 Pro For GuitarTurn on the Amp Model DOUBLE-PRESS to Adjust Tap delay tempo Press down To select Lower row Tap is set to Preset loads into Tone These knobs and buttons control only one Tone at a time Controls & Connections PODControls & Connections Controls & Connections Tempo that you’ve tapped Input 2/Microphone In and Trim plug in your microphone here Controls & Connections Join the Club POD X3 Live Controls & Connections 310 Controls & Connections Controls & Connections 313 314 315 POD X3 Pro 316Controls & Connections 318 319 320 321 322 323 Page Getting Around, Tones & Tuner HomeBlock not selectedBlock selected Turn to tweak lower row settings Dual Tone Concept Hold Tone Volume Controls Preset Folders Recalling Presets You can also choose to recall only ToneRecalling User Presets on POD X3 Live Or only ToneLocking Tone Saving Tones410 Tuner 440HZ411 Page Reference Tweaking Tones Amp + CabTone Controls Guitar Amp Model Tone ControlsBass Amp Model Tone Controls Stomp Boxes Distortion Stomp BoxesDynamics Stomp Boxes ReferenceTweaking Tones Modulation Effects ReferenceTweaking Tones Delay 510 Reverb Gate Compressor 513514 Wah 515Volume Pedal 516Effects Loop POD X3 Live & POD X3 Pro only MIXPage Reference Configuration & Setup InputsOutputs Reference Configuration & Setup Outputs Page 2 Studio/Direct Mix System Page 1 Pedal and other settings SystemSystem Page 2 Pedal and other settings Commands Page Example Setups Mono or Stereo Recording or Direct to Mixer/PARecording Tone 1 & 2 to Separate Mono Tracks Feed One Guitar Amp Feed Two Guitar Amps, One for Tone 1 and One for ToneFeed Two Guitar Amps, One Wet and One Dry Example Setups Example Setups Example Setups Page USB & Computer Software Updating POD X3, POD X3 Live or POD X3 Pro’s FirmwareSetting Up For USB Recording USB Sends When Operating In Stereo Tone Mode Page Ppendix IgnalFlow POD X3 Live POD X3 Pro
Top Page Image Contents