10 Rack Mounting
The
Please routinely check the mounting and chassis screws which can vibrate loose due to transportation and use. We recommend that at least once a month that the
Tube Replacement
One 12AX7 dual triode vacuum tube (valve) is at the heart of your
When to replace the preamp tube: Sometimes, tubes become noisy or “microphonic” (sounds like glass chimes during certain notes) as they wear out, but other times, tubes will fail without warning. If your amplifier stops working and other possible causes have been eliminated (fuses, cords, etc.), have an authorized service center inspect your amplifier tube.
Specifications
PART NUMBERS |
| 4400300010 (120V, 60Hz) USA | 4400303010 (240V, 50Hz) AUS |
|
| 4400304010 (230V, 50Hz) UK | 4400306010 (230V, 50Hz) EUR |
|
| 4400307010 (100V, 50Hz) JPN |
|
POWER REQUIREMENT |
| 840W |
|
POWER AMP | MINIMUM IMPEDANCE: | 4Ω |
|
| SENSITIVITY: | 1.67V RMS, 100Hz @ Mono Return |
|
| POWER OUTPUT: | 500W @ 4Ω (Bridge Mode); | 250W @ 4Ω per channel (Stereo Mode) |
|
| 400W @ 8Ω (Bridge Mode); | 150W @ 8Ω per channel (Stereo Mode) |
PRE AMP | INPUT IMPEDANCE: | 800kΩ (Passive/Active); | 60kΩ (Active) |
SENSITIVITY AT FULL POWER: | 22mV (Passive/Active); | 87mV (Active) | |
TONE CONTROLS | BASS: | ±15dB @ 80Hz |
|
| TREBLE: | ±15dB @ 2kHz |
|
| VARIABLE GRAPHIC EQ: | ±15dB @ Frequency knob setting |
|
| TRANSPARENCY: | ±15dB @ 5kHz |
|
EFFECTS LOOP | SEND IMPEDANCE: | 100Ω |
|
| RETURN IMPEDANCE: | 27kΩ |
|
BALANCED LINE OUT | SEND IMPEDANCE: | 1.5kΩ |
|
MAIN FUSES | T8A, 250V |
| |
| T4A, 250V |
| |
SPEAKER FUSES |
| F8A, 250V |
|
DIMENSIONS | HEIGHT: | 3.5 in (8.9 cm) |
|
| WIDTH: | 19 in (48.3 cm) |
|
| DEPTH: | 13.75 in (34.9 cm) |
|
WEIGHT |
| 25 lb (11.25 kg) |
|
Product specifications are subject to change without notice.
✧ s w r s o u n d . c o m ✧