To pair an individual microphone to the Base Station:
1.Turn the microphone OFF (no LED activity). If the microphone is ON, press and hold the Mute button for 10 seconds until the LED turns solid RED then release the button to turn the unit off. (do not release the button when you hear two beeps).
2.Place the microphone unit into pairing mode by holding the Mute button down for seven seconds. The LED will turn solid RED. Release the Mute button. The microphone is now in pairing mode.
3.Within one minute, push and hold the button for the desired channel on the Base Station for seven seconds until the LED turns solid red then release. The LED for that channel will be solid red until pairing starts, as indicated by a quick GREEN flash, then switching to flashing RED on both the microphone and the Base Station (muted audio). Pairing is now complete.
Revolabs Executive HD Charger Base
When Microphones are not in use, they should be properly inserted into the Executive HD Charger base. It is important to ensure that all system microphones are inserted fully in the base so that charging will occur. While charging in the Charger Base, the Charger Base USB connection may be used to either update HD Microphone firmware or ―Express Pair‖ the microphones to the Base Station. The microphone charging ports are numbered
1
2
3
4
1.LED indicator — power status indicator.
2.Charger Bays — charges up to 8 Microphones.
3.Mini USB Interface — computer serial interface for firmware upgrades to the microphones (on rear).
4.Power Cord Receptacle — power supply input,
- 32 -