08Using the tuner
memorize up to 30 stations, stored in three banks, or classes, (A, B and C) of 10 stations each. When saving an FM frequency, the MPX
setting (see previous page) is also stored.1
1Tune to a station you want to memorize. See Listening to the radio on the previous page for more on this.
2Press T.EDIT (TUNER EDIT).
The display shows ST. MEMORY, then a blinking memory class.
3 Press CLASS to select one of the three
classes then press ST to select the station preset you want.
You can also use the number buttons or the MULTI JOG dial (front panel) to select a station preset.
4 Press ENTER.
After pressing ENTER, the preset class and number stop blinking and the receiver stores the station.
Naming station presets
•The name is stored when ENTER is pressed after choosing the fourth character.
Tip
•To erase a station name, simply repeat steps 1 to 3 and input four spaces instead of a name.
•Once you have named a station preset, you can press DISP when listening to a station to switch the display between name and frequency.
Listening to station presets
You will need to have some presets stored to do this. See Saving station presets above if you haven’t done this already.
1Press FM, then press CLASS to select the class in which the station is stored.
Press repeatedly to cycle through classes A, B and C.
2 Press ST | to select the station preset |
you want. |
|
For easier identification, you can name your station presets.
1Choose the station preset you want to name.
•You can also use the number buttons on the remote control to recall the station preset.
See Listening to station presets below for how to do this.
2 Press T.EDIT (TUNER EDIT).
The display shows ST. NAME, then a blinking cursor at the first character position.
3 Input the name you want.
Choose a name up to four characters long.
•Use the MULTI JOG dial (front panel) or the
ST buttons (remote) to select characters.
•Press ENTER to confirm a character. If no character is input, a space is input.
Changing the frequency step
If you find that you can’t tune into stations successfully, the frequency step may not be suitable for your country/region. Here’s how to switch the setting:
1 Switch the receiver into standby.
2 On the front panel, press STANDBY/ ON while you press and hold the TUNER EDIT button.
The channel tuning step alternates between 10K STEP and 9K STEP each time you do this.
Note
1If the receiver is left disconnected from the AC power outlet for over a month, the station memories will be lost and will have to be reprogrammed.
48
En