Peavey V12 owner manual Exiting Edit Mode, Other ways to exit Edit Mode

micro mute system

Exiting Edit Mode

The normal way to exit from Edit Mode is to Press the blinking EDIT key.

The Console returns to Normal Operation Mode:

Other ways to exit Edit Mode:

If editing Next Scene(Mute/Pgm/Chan):Pressing GO puts the edited scene into Active Scene and then does a normal exit from Edit Mode into Operation Mode.Any * in the Next Scene display are maintained and also transferred to the Active Scene.This exit actually doesn’t change the data in the Next Scene memory (if STORE wasn’t pressed first),the edit buffer is transferred into the Active Scene, the original Next Scene data remains intact.This is useful for making a temporary change to a mute scene with- out affecting the stored info.

4 Recall Last:

The RECALL LAST key is used to bring back the previous Active Scene. This is useful when the operator jumps a cue and needs to get back to where he was before pressing that GO button.There is a "last buffer" data storage area that receives the contents of the previous Active Scene when GO is pressed.This buffer is over-written each time GO is used; it is only good for one recall at a time.The RECALL LAST sw will only be lit if there is data available to use. If it is lit and then pressed, it will perform its func- tion and then turn off until the buffer is again valid (next time GO is pressed).

Pressing RECALL LAST does the following:

1.The current Active Scene is transferred into the Next Scene Display.

2.The previous Active Scene is recalled from last buffer and put into Active Scene.

3. Any edits that were performed on the previousActive Scene(if edited when it was active) or on the current Active Scene are kept during this transfer(i.e. Asterisks are kept as flags for changes).

4.MIDI info is sent if present.

This is the sequence of events that happens when the GO button or the

RECALL LAST key is used:

Press GO:

Current Active Scene (with edits & flags) is placed into Last Buffer storage

Next Scene Buffer is placed into Active Scene

Next Scene increments up, RECALL LAST sw comes on

MIDI data of new Active Scene is omitted

Press RECALL LAST (if lit):

Current Active Scene(with edits & flags) is placed into Next Scene buffer

Last Buffer is placed into Active Scene

LAST lite goes off (Next Scene # is previous Active Scene #).

RECALL LAST sw now disabled.

MIDI data of new Active Scene is xmitted

p. 57