Peavey 112/212 EFX, 9/0180305014 operation manual EFX Specifications

Page 31

112 EFX SPECIFICATIONS

Power Amplifier Section:

Power measured with T. Dynamics® @ 100% (5% THD, 1 kHz, 120 VAC line)

Rated Power and Load:

65 W RMS into 8 Ohms

Frequency Response:

+3, -0 dB 100 Hz to 20 kHz @ 50 W RMS into 8 Ohms

Hum and Noise:

Greater than 90 dB below rated power

Power Consumption:

Domestic: 200 W @ 60 Hz, 120 VAC

Export: 200 W @ 50/60 Hz, 220-230 VAC

Preamp Section:

Preamp specs measured a 1 kHz with controls preset as follows:

Channel Select - Clean

Clean Mode Switch - Modern

Low and High EQ - 10

Mid EQ - 0

Lead Pre and Post Gain - 10

Lead Mode Switch - Vintage

Effects - Off

Nominal Levels - Clean Volume @ 5

Minimum Levels - Clean Volume @ 10

Preamp High Gain Input:

Impedance: High Z, 250 k Ohms

Nominal Input Level: -12.6 dBV, 234 mV RMS

Minimum Input Level: -23 dBV, 70 mV RMS

Maximum Input Level: 0 dBV, 1 V RMS

Effects Send:

Load Impedance: 1 k Ohms or greater

Nominal Output Level:

Effects Level: -8.4 dBV, 380 mV RMS

Effects Return:

Impedance: High Z, 22 k Ohms Designed Input Level:

Effects Level: -8.4 dBV, 380 mV RMS (Switching jack provides Effects Send to Effects Return connection when not used.)

System Hum and Noise @ Nominal Input Level:

(20 Hz to 20 kHz unweighted) Greater than 76 dB below rated power

Equalization:

Clean Channel:

Special Low, Mid, and High passive EQ Modern/Vintage Switch: Two distinct EQ voicings

Lead Channel:

Low, Mid, and High passive EQ Vintage/Modern/High Gain Switch: Three different EQ

and Gain voicings Presence fixed: 2 dB @ 7 kHz

Resonance fixed: 3 dB @ resonant frequency of cabinet

External Footswitch Functions:

Channel select; effects control

Dimensions:

18” H x 21.5” W x 10.75” D

(457 mm H x 546 mm W x 273 mm D)

Weight:

34.5 lbs. (16 kg)

Features and specifications subject to change without notice.

31

Image 31

Contents Page PRECAUCIONRiesgo de descarga eléctrica ¡NO Abrir 212 EFX FeaturesTranstube EFX Amplifiers 112 EFXFeatures and Controls Channel Select EFX AdjustLead Channel EQ Post Gain112 EFX 212 EFX Power SwitchIEC Connector Back PanelHeadphone Jack Remote Switch ConnectorGround Polarity Switch Power AMPEFX Select Mode FootswitchMode Select Preset Select ModeCreating and Storing a Custom Preset Tweak FeaturesTweak ADJ Parameters Suggested Settings Clean Transtube EFX Block DiagramPreamp Section EFX SpecificationsPreamp Output Características Transtube EFX AmplificadoresControles Y Caracterísiticas Ajuste DE Efecto EQ DEL Canal LíderPost Ganancia Selector DE CanalCable DE Corriente Domestico EN Eeuu Interruptor DE CorrientePanel Trasero Conectador IECConectador DE Parlante Externo Conectador DE AuricularesCircuíto DE Efectos Interruptor DE Cambio DE PolaridadModo DE Selcción DE Efectos Modo DE Selección DE PresetsPedalera Selección DE ModoCreando Y Salvando UN Preset Personalizado Características DE CambiosParámetros DE Cambio Page Especificaciones DEL EFX Preamp Low Gain Input Caracteristiques Transtube EFX AmplificateurEQ Canal Clair Caracteristiques ET ControlesPanneau Avant Entree High Gain Commutateur Modern / VintageParametres EFX ADJ Resonance Switch *212 UniquementPrise Casque D’ECOUTE Panneau ArriereConnecteur IEC Connecteur PedalierSortie Preamp Ground Polarity Switch Sortie HAUT-PARLEUR ExterneEntree Power AMP Boucle D’EFFETSMode EFX Select Mode Preset SelectPedalier Parametres Secondaires Trucs ET AstucesEFX Specifications Preamp Low Gain Input Merkmale TRANSTUBE-VERSTÄRKERMODERN/VINTAGE-SCHALTER Funktionen UND ReglerVorderseite Input High Gain Input LOW Gain *NurRESONANCE-SCHALTER *Nur Presence *NurWECHSELSTROM-NETZKABEL FÜR DIE USA NetzschalterRückseite IEC-STECKEREffektschleife KopfhörerklinkeERDUNGSPOLARITÄT-SCHALTER Fussschalter Preset SELECT-MODUSEFX SELECT-MODUS Funktionen ZUR Feineinstellung Tweaks Erstellen UND Speichern Persönlicher PresetsPage EFX Specifications Preamp Low Gain Input Page Page Page Important Safety Instructions Peavey Electronics Corporation Limited Warranty 80305014