Peavey 112/212 EFX, 9/0180305014 operation manual EFX Specifications

Page 41

112 EFX SPECIFICATIONS

Power Amplifier Section:

Power measured with T. Dynamics® @ 100% (5% THD, 1 kHz, 120 VAC line)

Rated Power and Load:

65 W RMS into 8 Ohms

Frequency Response:

+3, -0 dB 100 Hz to 20 kHz @ 50 W RMS into 8 Ohms

Hum and Noise:

Greater than 90 dB below rated power

Power Consumption:

Domestic: 200 W @ 60 Hz, 120 VAC

Export: 200 W @ 50/60 Hz, 220-230 VAC

Preamp Section:

Preamp specs measured a 1 kHz with controls preset as follows:

Channel Select - Clean

Clean Mode Switch - Modern

Low and High EQ - 10

Mid EQ - 0

Lead Pre and Post Gain - 10

Lead Mode Switch - Vintage

Effects - Off

Nominal Levels - Clean Volume @ 5

Minimum Levels - Clean Volume @ 10

Preamp High Gain Input:

Impedance: High Z, 250 k Ohms

Nominal Input Level: -12.6 dBV, 234 mV RMS

Minimum Input Level: -23 dBV, 70 mV RMS

Maximum Input Level: 0 dBV, 1 V RMS

Effects Send:

Load Impedance: 1 k Ohms or greater

Nominal Output Level:

Effects Level: -8.4 dBV, 380 mV RMS

Effects Return:

Impedance: High Z, 22 k Ohms Designed Input Level:

Effects Level: -8.4 dBV, 380 mV RMS (Switching jack provides Effects Send to Effects Return connection when not used.)

System Hum and Noise @ Nominal Input Level:

(20 Hz to 20 kHz unweighted) Greater than 76 dB below rated power

Equalization:

Clean Channel:

Special Low, Mid, and High passive EQ Modern/Vintage Switch: Two distinct EQ voicings

Lead Channel:

Low, Mid, and High passive EQ Vintage/Modern/High Gain Switch: Three different EQ

and Gain voicings Presence fixed: 2 dB @ 7 kHz

Resonance fixed: 3 dB @ resonant frequency of cabinet

External Footswitch Functions:

Channel select; effects control

Dimensions:

18” H x 21.5” W x 10.75” D

(457 mm H x 546 mm W x 273 mm D)

Weight:

34.5 lbs. (16 kg)

Features and specifications subject to change without notice.

41

Image 41

Contents Page PRECAUCIONRiesgo de descarga eléctrica ¡NO Abrir Transtube EFX Amplifiers Features112 EFX 212 EFXFeatures and Controls Lead Channel EQ EFX AdjustPost Gain Channel SelectIEC Connector Power SwitchBack Panel 112 EFX 212 EFXGround Polarity Switch Remote Switch ConnectorPower AMP Headphone JackMode Select FootswitchPreset Select Mode EFX Select ModeTweak ADJ Parameters Tweak FeaturesCreating and Storing a Custom Preset Suggested Settings Clean Transtube EFX Block DiagramPreamp Section EFX SpecificationsPreamp Output Características Transtube EFX AmplificadoresControles Y Caracterísiticas Post Ganancia EQ DEL Canal LíderSelector DE Canal Ajuste DE EfectoPanel Trasero Interruptor DE CorrienteConectador IEC Cable DE Corriente Domestico EN EeuuCircuíto DE Efectos Conectador DE AuricularesInterruptor DE Cambio DE Polaridad Conectador DE Parlante ExternoPedalera Modo DE Selección DE PresetsSelección DE Modo Modo DE Selcción DE EfectosParámetros DE Cambio Características DE CambiosCreando Y Salvando UN Preset Personalizado Page Especificaciones DEL EFX Preamp Low Gain Input Caracteristiques Transtube EFX AmplificateurPanneau Avant Entree High Gain Caracteristiques ET ControlesCommutateur Modern / Vintage EQ Canal ClairParametres EFX ADJ Resonance Switch *212 UniquementConnecteur IEC Panneau ArriereConnecteur Pedalier Prise Casque D’ECOUTEEntree Power AMP Ground Polarity Switch Sortie HAUT-PARLEUR ExterneBoucle D’EFFETS Sortie PreampPedalier Mode Preset SelectMode EFX Select Parametres Secondaires Trucs ET AstucesEFX Specifications Preamp Low Gain Input Merkmale TRANSTUBE-VERSTÄRKERVorderseite Input High Gain Funktionen UND ReglerInput LOW Gain *Nur MODERN/VINTAGE-SCHALTERRESONANCE-SCHALTER *Nur Presence *NurRückseite NetzschalterIEC-STECKER WECHSELSTROM-NETZKABEL FÜR DIE USAERDUNGSPOLARITÄT-SCHALTER KopfhörerklinkeEffektschleife EFX SELECT-MODUS Preset SELECT-MODUSFussschalter Funktionen ZUR Feineinstellung Tweaks Erstellen UND Speichern Persönlicher PresetsPage EFX Specifications Preamp Low Gain Input Page Page Page Important Safety Instructions Peavey Electronics Corporation Limited Warranty 80305014