FOOTSWITCH
EFX
SELECT
MODE
28 29
CHANNEL | MODULATION | DELAY |
|
| REVERB |
|
|
| PFCTM3 | 2 |
|
| 3 |
|
| ||
| 1 |
|
|
|
| ||||||
PRESET |
| TO STORE PRESET |
|
| PRESET |
|
| PRESET | |||
30 |
| 31 |
| 32 |
| 33 |
| 34 |
| 35 |
|
|
|
|
|
|
| ||||||
|
|
|
|
|
| ||||||
MODE SELECT
The PFC 3 footswitch operates in two modes: EFX Select mode and Preset Select mode. Pressing the MODE SWITCH (28) selects between the two modes. The active mode is indicated by the MODE LED (29). Illumination of the LED indicates EFX Select Mode; a dark LED indicates Preset Select Mode. Controls and indicators
PRESET SELECT MODE
In this mode, all three switches control effects presets. Their corresponding LEDs indicate which preset is active. Once desired settings are achieved utilizing the effects controls on the front panel,
For a detailed explanation on creating and storing presets, refer to the TWEAK FEATURES section of this manual on the following page.
EFX SELECT MODE
NOTE: When entering this mode, the current preset will remain active.
In this mode, SWITCH 1 (30) selects between the Lead and Clean channels. The CHANNEL LED (31) will illuminate when the Lead channel is active. SWITCH 2 (33) toggles between two effects and their respective settings. This switch may be used as an on/off switch if one of the settings has no effects active. To use the MODULATION LED (32) as a status indicator, the “off” (or lower setting) should be made with the LED dark, and the “on” (or higher setting) made with the LED illuminated. SWITCH 3 (35) toggles between two reverb and delay settings. As with effects settings, this switch may be used as an on/off for reverb and delay. Both functions change simultaneously when this switch is depressed.
8