Fostex MR-8 owner manual Rear panel

MR-8 Owner’s Manual

Rear panel

POWER USB FOOT SW

DC IN ON

OFF LIGHT

			INT MIC	MIC/LINE
		DIGITAL		GUITAR
12V	[NORMAL MODE]	OUT	INPUT A SELECT

1 2 3 4 5

1. [DC IN] jack

Connect the supplied AC adaptor to this jack (see page 17).

2. [POWER] switch

Used to turn on or off the power.

By setting the switch to "LIGHT", the backlight of the LCD display lights up (see page 18).

<Note>

When driving the MR-8 by batteries, we rec- ommend not to use the backlight, because the batteries are exhausted quickly.

6

<Note>

When you open the MR-8 carton, the protec- tion cap is inserted to the [DIGITAL OUT] con- nector. When using the connector, remove the cap. When no connection is made to the connector, keep the cap inserted.

3. [USB] port

Used to connect with a personal computer using a standard USB cable (see page 88).

4. [FOOT SW] jack

Used to connect with the optional footswitch (Model 8051) or an unlatched-type footswitch (see page 35).

5. [DIGITAL OUT] connector

Used to connect with an external digital device (see page 48).

<Note>

Only song data created by the normal mode (44.1 kHz, 16 bit) can be digitally output from this port.

Song data created by the extended mode can- not be digitally output.

6. [INPUT A SELECT] switch

This switch must be set appropriately according to the input source of the [INPUT A] section (see page 29).

	Set the switch to this position when the source
MIC/LINE	is an external microphone or line level source.
	Both the [BAL] XLR and [UNBAL/GUITAR]
	phone connectors can be used.
	Set the switch to this position when the source
GUITAR	is a guitar connected to the phone connector.
	Both the [BAL] XLR and [UNBAL/GUITAR]
	phone connectors can be used.
	Set the switch to this position when the source
INT MIC	is the built-in microphone.
	Both the [BAL] XLR and [UNBAL/GUITAR]
	phone connectors cannot be used.

14