Fostex MR-8 owner manual Erasing a desired part

MR-8 Owner’s Manual

Erasing a desired part

You can erase a desired part on the selected mono or stereo track(s).

LOCATE A LOCATE B

	point	point
ABS ZERO		REC END
TRK 1
TRK 2
TRK 3		Silent
TRK 4
TRK 5
TRK 6
TRK 7
TRK 8

<Note>

You cannot erase a part of a song protected. Release the protection before erasing the part.

1)Load the song you want to edit.

2)Store the LOCATE A and LOCATE B points (see page 53).

You can check the part by playing back between the LOCATE A and LOCATE B points (see page 68).

3)While the recorder is stopped, press the [MENU] key to enter the menu mode.

The display shows the menu selection screen, in which "System" is highlighted initially.

4)Use the [CURSOR ] key to highlight "Part", then press the [ENTER] key.

The display now shows the part edit menu selec- tion screen, in which "Erase Part" is highlighted ini- tially.

The display now shows the screen for selecting the target track(s) which the desired part to be erased belongs to. The current position information (in ABS, Bar/Beat or time counter base) is shown at the top of the screen.

flashing

6)Use the [CURSOR /] keys to select a mono track or a pair of stereo tracks.

You can select from among mono tracks (1 through 8) and stereo pair tracks (1/2, 3/4, 5/6 and 7/8).

7)Use the [CURSOR ] key to move the cursor to "[ENTER]" at the lower right on the screen, then press the [ENTER] key.

The display shows "Please Wait!", immediately fol- lowed by "Completed!" when the MR-8 completes erasing.

If you want to cancel the erase operation, move the cursor to "[CANCEL]" on the screen, then press the [ENTER] key.

8)Press the [ENTER] key.

The display returns show to the screen in which "Erase Part" is highlighted.

5)While "Erase Part" is highlighted, press the [ENTER] key.

9) Press the [MENU] key to exit the menu mode.

<Note>

If you are not satisfied with the result, press the [UNDO/REDO] key to undo the opera- tion (see page 68).

69