Fostex MR-8 owner manual Changing the bar number or signature, Use the Cursor / keys to enter

MR-8 Owner’s Manual

flashing

5) Use the [CURSOR /] keys to enter "4".

flashing

6)Use the [CURSOR ] key to flash "4/4" for "Sig." setting.

You can select a desired signature from among 1/4, 2/4, 3/4, 4/4, 5/4, 1/8, 2/8, 3/8, 4/8, 5/8, 6/8, 7/8 and 8/8.

9)Use the [CURSOR ] key to highlight "---bar -> ---", then press the [ENTER] key.

The display shows the screen for new signature setting as step 4 above. Follow the same procedure as described above until you finish all settings. You can make up to 64 bar/signature settings.

10)After completing all settings, use the [CURSOR ] key to return the display to show the screen in which "Signature Map" is highlighted.

Then, continue to the procedure for tempo setting described on page 82.

To edit the signature map you created, see below.

flashing

7) Use the [CURSOR /] keys to enter "3/4".

Changing the bar number or signature

You can change the bar number or signature you specified.

1)While the display shows the signature map screen, use the [CURSOR /] key to highlight the setting you want to change, then press the [ENTER] key.

The display changes to show the screen where the bar number flashes, showing that you can now edit it.

flashing

8)Use the [CURSOR ] key to move the cursor to "[ENTER]" at the lower center of the screen, then press the [ENTER] key.

The bar and signature setting above is completed and the display changes to show the signature map screen, in which the new setting is reflected.

flashing

80